Currently, the processes of obtaining synthetic liquid hydrocarbons and oxygenates are very relevant. Fischer-Tropsch synthesis (FTS) is the most important step in these processes. The products of thermal destruction in argon of the mixture [Co(NH3)6][Fe(CN)6] and Al(OH)3 were used as catalysts for CO hydrogenation. The resulting compositions were studied using powder X-ray diffraction, IR spectroscopy, elemental analysis, SEM micrographs. The specific surface area, pore and particle size distributions were determined. It was determined that the DCS-based catalysts were active in the high-temperature Fischer-Tropsch synthesis. The effect of aluminum in the catalyst composition on the distribution of reaction products was revealed.
1 June 2022 in Russian Journal of General Chemistry
Nanocrystalline ytterbium zirconate Yb4Zr3O12 (δ-phase) was synthesized by the solid-state method with preliminary mechanical activation of a stoichiometric mixture of the corresponding oxides. The processes occurring in the course of the synthesis were studied by X-ray powder diffraction, IR spectroscopy, and thermal analysis. The average size of Yb4Zr3O12 crystallites obtained by annealing a mechanically activated oxide mixture at 900, 1000, 1100, and 1200°C was calculated by the Scherrer formula and was 12, 17, 27, and 41 nm, respectively.
The Murmansk region has a significant amount of sulfide copper-nickel raw materials. Deposits of the Nud massif associated with Monchepluton are promising for processing. The Nud II deposit cut-off grade ore with an initial Ni content of 0.45 % and Cu of 0.39 % has been chosen as the research object. During the research, the ore was mixed with ammonium sulfate, grinded, and the mixture was roasted in a muffle furnace with static air atmosphere. The roasted mixture was leached in heated distilled water with constant stirring. The maximum metals recovery was achieved when crushing to a fraction of –40 µm, the ratio of ore : ammonium sulfate is equal to 1 : 7, roasting temperature 400 °C, roasting duration 300 min. In the mixture roasted at these parameters, reflexes of copper and nickel sulfates were recorded by the x-ray phase analysis (XRD) method. At the stage of water leaching, the maximum recovery was: Ni – 79.1 %, Cu – 75.8 %.
Double complex salts (DCSs) of the composition [Co(NH3)6][Fe(CN)6] are a promising precursor for the preparation of catalysts for the hydrogenation of carbon oxides (CO and CO2) by Fischer–Tropsch synthesis. The specific surface area is an important parameter for catalysts. Our article investigates the influence of mechanochemical activation (MCA) on this DCS in order to determine the conditions for obtaining the largest specific surface area of the intermetallic compound, a product of the DCS thermolysis. In this work, the effect of MCA on the physicochemical properties of the DCS [Co(NH3)6][Fe(CN)6] and the products of its thermal decomposition in an argon atmosphere were investigated. It was shown that MCA leads to partial reduction of Fe+3 to Fe+2, changes in the coordination of ammonia, amorphization of the structure and a decrease in the thermal stability of DCS. Thermolysis at 650 °C of samples subjected to MCA for 10 min results in the formation of nanocrystalline intermetallic compound Co0.5Fe0.5. The results demonstrate the potential of using MCA to control the properties of functional materials based on DCS.