Emiliano Martinez

Dr. Emiliano Martinez

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 February 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
RGRafał Grądzki
Rafał Grądzki
BBBłażej Bartoszewicz
Błażej Bartoszewicz
EMEmiliano Martinez
Emiliano Martinez
The article presents an adaptation of a parametric diagnostic method based on the square of the amplitude gains model, which was tested in experimental studies on bearing damage detection (outer race, inner race, bearing balls damage). The described method is based on the shaft displacement signal analysis, which is affected by vibrations coming from the bearings. The diagnostic model’s parameters are determined by processing the signal from the time domain to the frequency domain in a few steps. Firstly, the recorded signal is divided into two observation periods, next the analytical autocorrelation functions are determined and approximated by a polynomial. Then, the diagnostic thresholds are adopted, and the model parameters are converted into damage maps that are easy to interpret and assess the technical condition of the bearings. The presented method shows the technical condition of bearings in a qualitative way. Depending on the received color damage maps, it is possible to determine their level of wear. Green and blue indicate poor wear or no damage, red indicates increased wear, and black clearly indicates a damaged bearing.

18 February 2026 in Materials
Verified
Journal Article
Open access
PDF file
JBJakub Backiel
Jakub Backiel
PDPaweł Dzienis
Paweł Dzienis
KGKarol Golak
Karol Golak
PZPrzemysław Zamojski
Przemysław Zamojski
MRMaciej Rećko
Maciej Rećko
RVRogelio Valdés
Rogelio Valdés
This paper investigates the feasibility of manufacturing hydraulic fittings using additive manufacturing (AM) technologies, specifically Fused Deposition Modeling (FDM) and Stereolithography (SLA). The study addresses the environmental challenge of material waste in conventional fitting production by exploring 3D printing as an alternative manufacturing method. Hydraulic fittings were designed using CAD software: SolidWorks 2022 and fabricated using FDM with PETG (Polyethene Terephthalate Glycol) material and SLA with UV-sensitive photopolymer resin. In present studies, on-destructive leak testing was conducted in accordance with PN-EN 1254-4 and PN-EN 1254, at pressures ranging from 0.1 to 1.0 bar. Dimensional accuracy analysis revealed shrinkage of approximately 1% for SLA-printed parts and 2% for FDM-printed parts. Microscopic examination at 50× and 80× magnification showed superior thread quality in SLA samples compared to FDM, which exhibited visible layer separation and material porosity. Leak testing demonstrated that while the brass reference fitting maintained complete seal integrity, both 3D-printed variants failed to achieve leak tightness under operational pressures, with structural failure occurring at 1.0 bar during tightening. The study showed that FDM with PETG material and SLA with UV-sensitive photopolymer resin, despite achieving acceptable dimensional tolerances (±1–2%), do not meet hydraulic leak tightness requirements at pressures exceeding 0.5 bar in their raw state after printing. The results suggest that alternative material formulations (e.g., carbon fiber-reinforced PEEK for FDM or epoxy engineering resins for SLA) warrant further investigation. Potential avenues for improvement include advanced surface treatment, optimization of printing parameters, and modifications to thread geometry to reduce interthread gaps.