Vertical cracks in concrete present a major challenge for many conventional nondestructive testing methods (NDT) and structural health monitoring (SHM) methods. Elastic wave-based approaches offer strong interaction with crack faces and depth sensitivity; however, their effectiveness is often limited by the lack of repeatable and tunable excitation sources. Repeatability is critical because scattered and attenuated signals require stacking to achieve adequate signal-to-noise ratios, while tunability is essential because key crack attributes are frequency-dependent and must be probed at appropriate wavelengths. In this study, we develop an active sensing system utilizing a linear impact actuator as a repeatable and tunable mechanical source for elastic-based NDT and apply it to a 0.24 m thick concrete slab containing three surface-breaking vertical cracks with depths of 6, 12, and 18 cm, respectively. The actuator is tuned by adjusting impact conditions to generate -dominated Lamb wave responses. For each crack, two linear arrays are deployed, one parallel and one perpendicular to the crack trace, to investigate directional anisotropy. Phase-velocity anisotropy is quantified using the Lamb wave dispersion curves, while the effective quality factor is used as a complementary indicator of direction-dependent attenuation. Our results show that phase velocities are consistently higher for crack-parallel propagation than for crack-perpendicular propagation, and that the degree of anisotropy increases with crack depth. The quality factor decreases with increasing crack depth and exhibits anisotropic behavior, with systematically lower values for crack-perpendicular measurements compared to crack-parallel measurements. Overall, the results demonstrate that controllable and repeatable impact excitation establishes a reliable framework for elastic-wave-based characterization of idealized vertical cracks in concrete.
Ground-based remote sensing of seismic and geophysical displacements remains a major challenge due to environmental hazards, signal attenuation, and practical deployment limitations of traditional seismometers. In this study, we present a detailed design, implementation, and performance evaluation of a Moiré-based apparatus for remote ground displacement measurement. The system operates by detecting fringe shifts formed between a fixed and a displaced grating, with displacement magnified through controlled angular superposition. We systematically assess each component of the system, including telescope optics, imaging sensors, and grating configurations, to optimize spatial resolution, contrast, and robustness under varying environmental conditions. A digital approach for fringe generation was employed, allowing controlled magnification and improved sensitivity without the need for physical alignment of dual gratings. Indoor experiments under low-turbulence conditions validated the system’s capability to detect displacements as small as . Subsequent outdoor trials at different distances demonstrated successful measurement of both square-wave and seismic-like displacements despite increased atmospheric turbulence and wind. The results confirm the system’s ability to perform real-time, long-range, non-contact displacement monitoring with high accuracy and resilience to environmental variability. This study establishes a foundation for the application of Moiré-based sensing in challenging field conditions, including volcanic and seismic zones.