The thin-skin calorimeter sensor is used to measure heat flux. This device is limited to measurements at a single physical location. A new method, denoted HFITS, has been developed to obtain heat flux measurements over a two-dimensional surface. A large flat plate sensor is positioned near a heat source at the location where field heat flux measurements are desired; exemplar plate sensor designs and property data are provided in this work to support method application. An infrared camera is used to measure the temperature of the plate sensor over time. Thermogram sequences are translated to a rectilinear grid, and a two-dimensional inverse heat transfer model is used to derive measurements of net heat flux to the plate sensor. Incident heat flux (consisting of both radiative and convective components) is calculated by applying numerical approximations, optimizations, and engineering correlations. A validation experiment was performed, and the HFITS method was shown to produce measurements consistent with Schmidt-Boelter heat flux gauges, having an RMSE of 0.5 kW m-2 for an incident radiative heat flux of 18 kW m-2 (< 3 %). Limitations of the method, such as response time, sensor survivability, noise, and measurement uncertainty, are detailed.•The HFITS method provides measurements of two-dimensional heat flux fields to a target location.•The plate sensor is simple to fabricate, inexpensive, and is practical to deploy in various thermal engineering applications.•Exemplar plate sensor designs, property data, and infrared camera considerations are provided to support method application.
2 June 2025 in International Journal of Heat and Mass Transfer
Pyrolysis models are used in the fire science field to simulate the thermal decomposition of materials. These models require knowledge of the kinetic and thermodynamic parameters of an assumed reaction mechanism, and the thermophysical properties of the virgin material and product species. Standard test methods exist for measuring the thermal conductivity of nonreactive materials, but to date no suitable method exists that is compatible with contemporary pyrolysis models and is applicable to thermally reactive materials. In the present study, a modified methodology was presented and evaluated to address this need. The methodology involves a preliminary assessment of thermal stability, followed by a series of tests including: thermogravimetric analysis, differential scanning calorimetry, and laser flash analysis. Once a reaction mechanism has been identified, gram‐scale samples of the virgin and stable product species are isolated and independent measurements of thermal conductivity of those species are obtained. The methodology was applied to eucalyptus fiber hardboard, for which a complete set of property data for pyrolysis modeling was obtained. A pyrolysis experiment was then conducted, and that experiment was simulated using a pyrolysis model parameterized with the measured property data. Model predictions of the mass loss rate and temperature rise of a hardboard sample exposed to radiant heat flux of 35 and 60 kW m−2 were found to be a good match to measurements. These results demonstrate the suitability of the property data, the pyrolysis model, and the utility of this approach. This work will serve as a basis for property determination in future pyrolysis studies.