A possibility of application of longitudinal bending (buckling) as an economical way of profiling workpieces, ensuring replacement of pinching impressions and edgers was shown for manufacturing of eye-bolt forgings. For realization of this method of impression-free profiling of blanks, a process of twin forging of eye-bolt forgings was designed as well as the arrangement of the forging facilities. The peculiarity of this process is that the cut-off blank is upset, it loses its stability and thus obtained profiled semi-finished product is turned over on its side and eventually it is put inside the impression for simultaneous forging of two forgings from one blank. It was found that profiled semi-finished items acquired the desired shape at the degree of blank’s upsetting equal to 39 %, the central angle between the twin eye-bolts forgings being 54° and it had been taken into account for the dies’ design. Experimental forming of eye-bolts forgings according to the proposed and conventional processes on physical lead models of blanks, which helped to find out that the proposed technical solution, can ensure metal saving at 21.7 % level. Comparison of these two methods revealed improved technical and economic indices of the new process; particularly the coefficient of metal consumption at cutting was raised by 1.4 %, the quotient of output of quality forgings by 21.1 % and coefficient of application of forgings metal along the consumption rate by 27.9 %.
The article provides the analysis of the structures of broadband hot rolling mills that confirmed the relevance of the use of induction heating of the pre-roll edges before the finishing mills in order to reduce the chilling end-effect. Adaptation to the production conditions of wide ultrafine sheets and strips of finite-difference recurrence mathematical model of temperature field variation allowed to develop recommendations for designing of slot inductors for reheating the edges of pre-rolled strips, taking into account the chilling end-effect of the edges, heating modes to achieve the required temperature distribution before rolling in the finishing mill groups. Calculations show that the temperature gradient across the strip width is from 30 to 150 Celsius degrees, depends on the time interval between the end of the rough rolling and the beginning of the deformation of the metal in the finishing mill. Special design of slot inductors makes possible to eliminate a temperature gradient.
The design of the elastic ring compensator of «press-and-die” system errors, the method and software for calculating its geometric parameters are given in the article. The developed method is based on the account of unevenness of the radial and altitudinal deformation (barrel-type shape) of the elastic working element made of polyurethane. A specific example of computer implementation of the developed mathematical model for calculating the sizes of such a compensator for steel-forming operations on an open-crank press is made. Approbation of the compensator was carried out in industrial conditions.