Chunyu Zhao

Dr. Chunyu Zhao

School of Mechanical Engineering and Automation, Northeastern University, Shenyang 110819, China

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 November 2009 in Acta Mechanica Sinica
Verified
Journal Article
Closed access
PDF file
CZChunyu Zhao
Chunyu Zhao
Hongtao ZhuHongtao Zhu
Hongtao Zhu
YZYimin Zhang
Yimin Zhang
BWBangchun Wen
Bangchun Wen

1 January 2011 in Journal of Mechanical Science and Technology
Verified
Journal Article
Closed access
PDF file
CZChunyu Zhao
Chunyu Zhao
QZQinghua Zhao
Qinghua Zhao
YZYimin Zhang
Yimin Zhang
BWBangchun Wen
Bangchun Wen

7 February 2020 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
ZLZhen-Jun Li
Zhen-Jun Li
CZChunyu Zhao
Chunyu Zhao
ZLZechen Lu
Zechen Lu

26 September 2017 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
TLTie-Jun Li
Tie-Jun Li
CZChunyu Zhao
Chunyu Zhao
YZYi-Min Zhang
Yi-Min Zhang

11 January 2022 in Polymers
Verified
Journal Article
Open access
PDF file
SJSHIJIE JIANG
SHIJIE JIANG
KHKe Hu
Ke Hu
YZYang Zhan
Yang Zhan
CZChunyu Zhao
Chunyu Zhao
XLXiaopeng LI
Xiaopeng LI
Material extrusion (ME), one of the most widely used additive manufacturing technique, has the advantages of freedom of design, wide range of raw materials, strong ability to manufacture complex products, etc. However, ME products have obvious surface defects due to the layer-by-layer manufacturing characteristics. To reveal the generation mechanism, the three-dimensional surface roughness (3DSR) of ME products was investigated theoretically and experimentally. Based on the forming process of bonding neck, the 3DSR theoretical model in two different directions (vertical and parallel to the fiber direction) was established respectively. The preparation of ME samples was then completed and a series of experimental tests were performed to determine their surface roughness with the laser microscope. Through the comparison between theoretical and experimental results, the proposed model was validated. In addition, sensitivity analysis is implemented onto the proposed model, investigating how layer thickness, extrusion temperature, and extrusion width influence the samples’ surface roughness. This study provides theoretical basis and technical insight into improving the surface quality of ME products.

1 March 2010 in Chinese Physics B
Verified
Journal Article
Closed access
CZChunyu Zhao
Chunyu Zhao
ZYZhang Yi-Min
Zhang Yi-Min
WBWen Bang-Chun
Wen Bang-Chun