Metal hydrides can safely store hydrogen in the solid state at high volumetric density under moderate temperature and pressure. Their hydrogen sorption characteristics are represented by pressure–composition–temperature (PCT) curves. AB5–type metal hydrides, which have low plateau pressures, store and release hydrogen at low pressures. AB2–type metal hydrides, which have high plateau pressures, store and release hydrogen at relatively high pressures. Compared with AB5–type metal hydrides, AB2–type metal hydrides generally have lower raw material costs and higher hydrogen storage capacity. This makes them more suitable for storing large quantities of hydrogen. Green and blue hydrogen are produced using commercial alkaline water electrolyzers and natural gas reformers, respectively. After downstream purification, this hydrogen is typically supplied at pressures below 1 MPa. However, the high plateau pressures of AB2–type metal hydrides make it difficult to store this low-pressure hydrogen directly. AB5–type metal hydrides can store it but release it only at low pressures. A single hydride type therefore operates within a narrow pressure range for both storage and delivery. In this study, a multipurpose hydrogen storage system (MHSS) using AB5– and AB2–type metal hydrides was proposed to broaden the applications of metal hydride-based systems. The feasibility of the MHSS was experimentally evaluated through lab-scale tests. The AB5 and AB2 modules were first tested as standalone units. The integrated MHSS was then tested assuming that waste heat was continuously available. The MHSS can store a large quantity of low-pressure hydrogen and deliver it across a wide pressure range. This range covers diverse end uses, from fuel cells at 0.5 MPa to hydrogen pipelines at 4.0 MPa.
Metal hydrides store hydrogen in the solid state with high density and inherent safety, and their thermodynamic characteristics are typically described by the pressure–composition–isotherm (PCI) curve. In the plateau pressure region of the PCI curve, the equilibrium pressure remains nearly constant over a wide hydrogen concentration range, making conventional pressure-based methods unsuitable for quantifying the hydrogen amount in metal hydride vessels. This study proposes a strain-based method to quantify the hydrogen amount in a metal hydride vessel by measuring the strain induced on the metal hydride vessel surface due to the volumetric change of the metal hydride during hydrogen adsorption and desorption. The installation of strain gauges on the metal hydride vessel was verified using argon pressurization tests. The metal hydride was activated prior to controlled hydrogen desorption experiments aimed at quantifying the amount of hydrogen remaining in the vessel. A correlation between strain and hydrogen amount was obtained from experiments conducted at discrete measurement points. The hydrogen amount estimated using the strain-based method was further evaluated through continuous time-series desorption tests and showed good agreement with the results obtained from the mass flow controller (MFC)-based method, with a maximum difference of 4.5%. These results demonstrate that the proposed method provides a simple and reliable approach for quantifying the hydrogen amount in metal hydride vessels.