Ahmed Ismail M. Ali

Dr. Ahmed Ismail M. Ali

South Valley University, Qinā, Egypt
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2018 in International Journal of Electrical Power & Energy Systems
Verified
Journal Article
Closed access
Ahmed Ismail M. AliAhmed Ismail M. Ali
Ahmed Ismail M. Ali
MSMahmoud A. Sayed
Mahmoud A. Sayed
EMEssam E.M. Mohamed
Essam E.M. Mohamed

24 July 2023 in IEEE Access
Verified
Journal Article
Open access
Ahmed Ismail M. AliAhmed Ismail M. Ali
Ahmed Ismail M. Ali
HMHossam H. H. Mousa
Hossam H. H. Mousa
HMHassanien Ramadan A. Mohamed
Hassanien Ramadan A. Mohamed
Salah KamelSalah Kamel
Salah Kamel
ASAbdurrahman Shuaibu
Abdurrahman Shuaibu
AAAbdel-Raheem Youssef Abdallah
Abdel-Raheem Youssef Abdallah
Due to improved efficiency of solar photovoltaic (PV) systems, this article proposes a modified perturb and observe (MPO) maximum power point tracking (MPPT) algorithm. The MPO algorithm in question adopts a tracking approach that divides the power-voltage curve into four operational regions based on the estimated open-circuit voltage. Additionally, this algorithm enhances the maximum power point (MPP) tracking method by reducing unnecessary step-size calculations, focusing only on a 10% section of the power-voltage curve that contains the MPP. Consequently, the two regions located far from the MPP, below 90% of the power-voltage range, utilize a large fixed step-size to ensure swift tracking speed. Furthermore, in the regions close to the MPP, the remaining areas employ a similar tracking strategy as the adaptive P&O algorithm, aiming to achieve minimal steady-state oscillations around the optimal MPP. The performance of the proposed MPO algorithm is demonstrated by validating it against sinusoidal, ramp irradiance, and one-day (10 hr.) irradiance profiles using MATLAB/SIMULINK. The simulation results confirm that the proposed algorithm outperforms recently published techniques in terms of convergence speed, achieving the shortest time of 15 ms, and slightly higher tracking efficiency of the PV system under uniform irradiation, reaching 99.8%.

1 May 2019 in International Journal of Electrical Power & Energy Systems
Verified
Journal Article
Closed access
AYAbdel-Raheem Youssef
Abdel-Raheem Youssef
Ahmed Ismail M. AliAhmed Ismail M. Ali
Ahmed Ismail M. Ali
MSMahmoud S.R. Saeed
Mahmoud S.R. Saeed
EMEssam E.M. Mohamed
Essam E.M. Mohamed

5 September 2018 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
Ahmed Ismail M. AliAhmed Ismail M. Ali
Ahmed Ismail M. Ali
MSMahmoud A. Sayed
Mahmoud A. Sayed
EMEssam Mohamed
Essam Mohamed
AAAhmed Azmy
Ahmed Azmy
This paper presents a new symmetrical single-phase nine-level DC-AC converter for the applications of distributed generation systems (DGS). The proposed multilevel inverter (MLI) utilizes four independent DC sources to generate the nine output voltage levels considering a reduced number of switching devices. The proposed inverter consists of main and auxiliary circuits. The main circuit is a single H-bridge circuit, which is responsible for output voltage polarity. The auxiliary circuit consists of a special combination of switching devices, which are used to synthesize the multilevel output voltage. The merits of the proposed MLI are: increased output voltage levels at reduced number of switching devices, low switching loss, low total harmonic distortion (THD), low dv/dt stress on the switches and hence, low ratings of the switching devices, and low cost. The effectiveness of the proposed MLI and its PWM switching pattern has been verified experimentally by using a laboratory prototype controlled by DSPACE-1103.

3 November 2023 in Scientific Reports
Verified
Journal Article
Open access
PDF file
AYAbdel-Raheem Youssef
Abdel-Raheem Youssef
MHMostafa M. Hefny
Mostafa M. Hefny
Ahmed Ismail M. AliAhmed Ismail M. Ali
Ahmed Ismail M. Ali
Partial shading of solar panels diminishes their operating efficiency and energy synthesized as it disrupts the uniform absorption of sunlight. To tackle the issue of partial shading in photovoltaic (PV) systems, this article puts forward a comprehensive control strategy that takes into account a range of contributing factors. The proposed control approach is based on using multi-string PV system configuration in place of a central-type PV inverter for all PV modules with a single DC-DC converter. This adaptation enhances overall efficiency across varying radiation levels. Also, the proposed technique minimizes the overall system cost by reducing the required sensors number by utilizing a radiation estimation strategy. The converter switching strategy is synthesized considering direct duty-cycle control method to establish the maximum power point (MPP) location on the P–V curve. The direct duty-cycle tracking approach simplifies the control system and improves the system’s response during sudden partial shading restrictions. To validate the effectiveness of the suggested MPPT method, two system configurations were constructed using MATLAB/SIMULINK software and assessed under various partial shading scenarios. Additionally, a multi-string system was subjected to real irradiance conditions. The sensor-less MPPT algorithm proposed achieved an impressive system efficiency of 99.81% with a peak-to-peak ripple voltage of 1.3V. This solution offers clear advantages over alternative approaches by reducing tracking time and enhancing system efficiency. The system findings undoubtedly support the theoretical scrutiny of the intended technique.

10 May 2021 in Energies
Verified
Journal Article
Open access
PDF file
Ahmed Ismail M. AliAhmed Ismail M. Ali
Ahmed Ismail M. Ali
MAMahmoud Abdallah
Mahmoud Abdallah
Osama MohammedOsama Mohammed
Osama Mohammed
This paper proposes a simple single-phase new pulse-width modulated seven-level inverter architecture for photovoltaic (PV) systems supporting home-grid with electric vehicle (EV) charging port. The proposed inverter includes a reduced number of power components and passive elements size, while showing less output-voltage total harmonic distortion (THD), and unity power factor operation. In addition, the proposed inverter requires simple control and switching strategies compared to recently published topologies. A comparative study was performed to compare the proposed inverter structure with the recent inverter topologies based on the number of components in the inverter circuit, number of components per output-voltage level, average number of active switches, THD, and operating efficiency as effective parameters for inverter performance evaluation. For design and validation purposes, numerical and analytical models for a grid-tied solar PV system driven by the proposed seven-level inverter were developed in MATLAB/Simulink environment. The inverter performance was evaluated considering grid-integration and stand-alone home with level-2 AC EV charger (3–6 kW). Compared with recently published topologies, the proposed inverter utilizes a reduced number of power components (7 switches) for seven-level terminal voltage synthesis. An experimental prototype for proposed inverter with the associated controller was built and tested for a stand-alone and grid-integrated system. Due to the lower number of ON-switches, the inverter operating efficiency was enhanced to 92.86% with load current THD of 3.43% that follows the IEEE standards for DER applications.