Plastics are widely used due to their versatility. However, their accumulation as microplastics and nanoplastics in the environment poses a significant threat for the ecosystems. Although biodegradable polymers, like polyhydroxybutyrate (PHB), offer a sustainable alternative, their degradation could still lead to fragmentation and MP accumulation, hence it is essential to enhance biodegradation rates in order to mitigate environmental impacts. This study investigates the integration of photocatalytic pretreatment with natural biodegradation to accelerate PHB biodegradation. Photoactive ZnO mesocrystals doped with biowaste-derived carbon nanodots, prepared via a wet-chemical approach, are proposed to improve the photocatalytic efficiency under sunlight. ZnO mesocrystals doped with 30 wt% of carbon nanodots exhibited superior photocatalytic properties, thus photodegrading PHB microplastics more efficiently than bare ZnO. Phototreated PHB microplastics exhibit an improved biodegradation in soil when exposed for a controlled irradiation time. Additionally, PHB microplastics photo-treated in the presence of doped mesocrystals showed an enhanced microbial colonization indicating improved biofilm formation. These findings highlight the potential of photocatalytic pretreatment in modifying surface properties to boost degradation in soil, thus offering a promising strategy for reducing microplastic accumulation.
Plastic waste is estimated to represent 40–80% of the total amount of marine litter, with polyethylene (PE) and polypropylene (PP) being the most abundant polymeric components. The recovery and recycling of marine plastic debris are therefore essential to mitigate environmental pollution and limit the generation of secondary microplastics. In this work, a mechanical recycling strategy was investigated for the valorization of a polyethylene-rich plastic fraction (PE-rf) recovered from the marine environment, characterized by high heterogeneity and persistent inorganic contamination. Different pre-treatment routes, including cryogenic grinding and planetary ball milling, as well as blending approaches with recycled polyethylene and compatibilizing additives, were explored. The effects of composition and processing on the thermal, mechanical, and morphological properties of the resulting materials were systematically analyzed. The results show that intense mechanical homogenization and chemical compatibilization are not sufficient to overcome the intrinsic limitations imposed by contamination and compositional variability. As a proof of concept, selected formulations were processed into filaments and tested in fused filament fabrication, demonstrating basic 3D printability.