Hydrothermal carbonization (HTC) of agricultural waste is a promising waste management technique. However, the use of different raw materials may produce hydrochars with varying efficiencies, both in yield and application, and environmental impacts, due to differences in composition and required processing conditions. To understand the influence of biomass type and acid-assisted HTC conditions, this study used sugarcane and agave bagasse to produce functionalized hydrochars and evaluated them for the removal of Reactive Orange 84; an azo dye used in the textile industry. Material characterization was performed using FT-IR, TGA, BET, and XRD analyses. In addition, a life cycle assessment was conducted to evaluate environmental impacts associated with hydrochars produced using H2SO4 at concentrations of 0.2 and 0.5 M. TGA and XRD results indicate that agave bagasse hydrochars (HBA) retain more crystalline lignocellulosic structures, whereas sugarcane bagasse hydrochars (HBS) exhibit predominantly amorphous structures after HTC. FT-IR analysis confirmed the presence of –SO3H functional groups; however, HBA samples showed greater availability of these groups with increasing acid concentration. Adsorption experiments and LCA results demonstrated that the most favorable treatment, in terms of emission reduction and dye removal, was agave bagasse functionalized with 0.5 M H2SO4, achieving 75.7% mass yield and 94.5% dye removal.
Decarbonizing the process heat required for chemical recycling would improve the environmental performance of plastic-waste valorization. This study presents an evaluation of the use of concentrated solar thermal energy as the reaction heat source for the hydrothermal depolymerization of post-consumer polyethylene terephthalate (PET). The solar-driven hydrothermal process (HTP-S) maintained an internal reactor temperature of approximately 200 °C for 4 h under favorable irradiance conditions. During the single experimental run, the system received 14.95 MJ of incident solar energy, whereas the conventional hydrothermal process (HTP-C) consumed 47.52 MJ of electricity per run. Starting from 1.2 g of PET, HTP-C and HTP-S produced 0.862 and 0.895 g of dry recovered solid, corresponding to recovered-solid yields of 71.7% and 74.5%, respectively. Fourier-transform infrared (FT-IR) spectroscopy, thermogravimetric analysis and derivative thermogravimetry (TGA/DTG), transmission electron microscopy (TEM), and X-ray diffraction (XRD) showed that the recovered solids exhibit physicochemical characteristics consistent with the formation of a crystalline terephthalic acid (TPA)-rich product. A cradle-to-gate life cycle assessment normalized to 1 kg of treated PET showed that cumulative energy demand decreased from 44,383.7 MJ for HTP-C to 7342.5 MJ for HTP-S, while global warming impacts decreased from 9717 to 1607 kg CO2-eq. These results demonstrate the technical feasibility of coupling concentrated solar heating with hydrothermal PET depolymerization and identify reaction heating as the principal opportunity for reducing external electricity demand. These outcomes indicate that solar-powered hydrothermal processing provides a feasible pathway for PET recycling, reducing the environmental footprint.