Biosolubility is an important parameter in the understanding of mechanisms involved in pulmonary toxicity of fibrous materials. It can be studied in vitro using models of simulated lung fluids and observing the loss of structural molecules, expressed as dissolution constant (K_dis). The aim of this paper was the study of dissolution behaviour of four wools belonging to high temperature insulation wools (HTIW) in saline solutions simulating lung fluids. Four HTIW were studied in saline solutions at pH 7.4 (representative of the extracellular environment) and 4.5 (representative of the intracellular conditions): refractory ceramic fibers (RCF), two alkaline earth silicate wools (AES1 and AES2 with high calcium and magnesium content respectively), and polycrystalline wools (PCW). Size, morphological and chemical changes of fibers were observed by scanning electron microscopy (SEM) with energy-dispersive X-ray spectrometry (EDS) and inductively coupled plasma atomic emission spectrometry (ICP-AES). RCF, AES2 and PCW did not show statistically significant diameter changes. AES1 size distribution shifted to a larger mean diameter suggesting that through dissolution there was a preferential loss of thin fibers at acid pH after 14 days of treatment. Both AES wools showed selective leaching of alkali/alkali earth oxides (incongruent dissolution) at pH 7.4: a fast and extensive selective leaching of calcium for AES1 with complete dissolution of fibers already after 14 days of treatment and a moderate selective leaching of magnesium for AES2. PCW showed some transversal breakage of the fibers in both pH environments (low congruent dissolution). For RCF, the treatment produced uncorroded fibers in both pH environments without chemical changes and fiber fragmentation (no dissolution). The estimated K_dis at physiological pH followed the sequence: AES1 > AES2 > PCW > RCF. All wools had a low K_dis at acid pH suggesting a low dissolution rate of short fibers. The leaching process and transverse fragmentation play an important role in the biopersistence mechanisms and pathogenicity of fibers and the K_dis estimate is undoubtedly useful as a preliminary toxicological screening of fibers, especially for developing fibers.

This study focuses on the dissolution process and surface characterization of amosite fibres following interaction with a mimicked Gamble’s solution at a pH of 4.5 and T = 37 °C, up to 720 h. To achieve this, a multi-analytical approach was adopted, and the results were compared to those previously obtained on a sample of asbestos tremolite and UICC crocidolite, which were investigated under the same experimental conditions. Combining surface chemical data obtained by XPS with cation release quantified by ICP-OES, an incongruent behaviour of the fibre dissolution was highlighted for amosite fibres, similarly to asbestos tremolite and UICC crocidolite. In particular, a preferential release of Mg and Ca from the amphibole structure was observed, in agreement with their Madelung site energies. Notably, no Fe release from amosite fibres was detected in our experimental conditions (pH of 4.5 and atmospheric pO₂), despite the occurrence of Fe(II) at the M(4) site of the amphibole structure, where cations are expected to be rapidly leached out during mineral dissolution. Moreover, the oxidation of both the Fe centres initially present on the fibre surface and those promoted from the bulk, because of the erosion of the outmost layers, was observed. Since biodurability (i.e., the resistance to dissolution) is one of the most important toxicity parameters, the knowledge of the surface alteration of asbestos possibly occurring in vivo may help to understand the mechanisms at the basis of its long-term toxicity.

In Italy, use and production of asbestos and asbestos-containing materials (ACMs) were banned in 1992, however, the risk of exposure to asbestos still exists, because most ACMs are located in industrial and public buildings. A total of 111 Italian buildings with friable and non-friable ACMs were surveyed; 500 air samples were collected in the areas where contamination might have occurred. Airborne asbestos fiber concentration calculated from air samples was averaged for each building. Statistical analysis of the data showed no significant differences between the mean concentration measured in buildings with friable and non-friable ACMs (p = 0.258). The concentration values were below 2 f/L, the value stated by Italian regulation to ensure that the area is safe to reoccupy after asbestos removal. Samples of settled dust were also collected. The presence of asbestos fibers in the dust showed the occurrence of a release of asbestos from the material. Although the airborne asbestos fiber concentrations measured were low, current Italian regulation requires an asbestos management program. The Public Institution to which the authors of this work belong encourages asbestos removal as the preferred abatement method, in line with the asbestos-free future approach proposed by the European Commission.

Airborne particulate matter (PM) poses a major health risk, yet species selection for vertical greening systems (VGS) is poorly quantified. We evaluated PM retention by seven commercially available shade-tolerant species grown in a modular living wall system (LWS) on a north-facing façade at Sapienza University of Rome. After 3 months of in situ exposure, leaves were analyzed via SEM (1000×), collecting 210 images, 30 per species. An automated FIJI/ImageJ pipeline segmented particles, computed equivalent circular diameters, and classified them into (PM < 0.5, PM [0.5, 1), PM [1, 2.5), PM [2.5, 10), and PM ≥ 10 µm). Across species, ultrafine and fine fractions dominated deposits, with the 10 µm). Heuchera sanguinea consistently displayed the lowest densities across all size classes. Performance patterns aligned with leaf surface traits: wax-coated, moderately rough or gently structured cuticles favored adhesion, whereas highly irregular microrelief did not consistently enhance retention. Methodological considerations include thresholding sensitivity, use of equivalent circular diameter for irregular particles, and an upper area filter that may undercount large aggregates. The findings identify Vinca minor cv. albomarginata and Fatsia japonica as priority species for PM mitigation in shaded VGS, with Hedera helix complementing coarse PM capture. The results provide trait-based, design-oriented guidance for living wall species selection in Mediterranean urban and indoor contexts.