To address early water breakthrough and poor residual-oil mobilization in low-permeability reservoirs, a core–shell nanosphere/surfactant composite system was developed for profile control and enhanced oil recovery. The core–shell nanospheres were prepared by a semi-continuous seed-growth method, and a target particle-size window of 100–200 nm was selected based on pore-throat/particle matching. The representative sample, HK-0417, had an average particle size of about 120 nm and showed good dispersion stability in formation brine at 45 °C. After blending with the surfactant ALT-603, the system achieved an ultralow oil–water interfacial tension on the order of 10−3 mN/m and reduced the water contact angle of the oil-aged surface from 125° to 70°, indicating a shift toward near-neutral wettability. Core-flooding tests further showed that, under the same chemical dosage, slug injection (HK-0417 followed by ALT-603) demonstrated better performance than co-injection, with higher incremental oil recovery (15.49% vs. 13.17%) and higher plugging efficiency during subsequent water flooding (81.25% vs. 78.46%). The novelty of this work lies in integrating particle-size-window design, controllable preparation of core–shell nanospheres, and direct comparison of injection strategies within one system. The results provide practical guidance for formulation design and injection-mode selection for enhanced oil recovery in low-permeability reservoirs.
Low-permeability reservoirs at the high-water-cut stage commonly suffer from dominant water channel development, poor sweep of weakly connected zones, and inefficient mobilization of remaining oil. Existing profile control or oil displacement agents can improve either flow diversion or microscopic oil displacement, but their single-agent evaluation does not fully explain the coupled process of sweep expansion and remaining oil mobilization. To address this issue, this study focuses on a previously optimized HK-0417/ALT-603 composite system and investigates its synergistic behavior at pore, core, and well group scales. Microscopic visualization displacement experiments were used to identify streamline redistribution and remaining oil evolution. Natural core experiments were conducted to evaluate injectivity adaptability and plugging persistence. Under slug injection conditions, the Box–Behnken design was employed to optimize the injection parameters. Finally, the field pilot response was analyzed based on production data from test wells in the Changqing Oilfield. The results show that the combination system simultaneously achieves streamline expansion and residual oil reduction: the injected fluid is redistributed toward weakly swept zones, large continuous oil bodies are fragmented and dispersed, and both sweep efficiency and oil displacement efficiency are superior to those of individual agents. Natural core experiments indicate that the injection pressure difference is generally controllable in cores with permeabilities ranging from 1.76 to 7.02 mD, and the plugging rate during subsequent water flooding reaches 75.47–80.54%. Response surface optimization yields the following optimal parameter combination: profile control slug volume = 0.41 pore volume (PV), oil displacement slug volume = 0.61 PV, injection rate = 0.19 mL/min, with a corresponding predicted enhanced oil recovery (EOR) of 18.52%. In the field pilot, the cumulative injection volumes of the two injectors are 41,898 kg and 61,472 kg, respectively. The injection pressure in the well group increases from 5.8 MPa to 7.0 MPa, the comprehensive water cut decreases from 90.6% to 85.3%, and the monthly decline rate is reduced from 0.5% to 0.2%. The proposed system mainly acts by increasing flow resistance and redirecting flow in high-water-cut channels, while it enhances oil detachment through interfacial tension reduction in oil-bearing pores. After optimizing the slug parameters, the field pilot exhibits a clear phased response and promising application potential.