The use of a single porous mixed ion-electron conducting (MIEC) material as both the oxygen and fuel electrodes in reversible solid oxide cells is of increasing interest, primarily due to the resulting simplified cell design and lower manufacturing costs. In this work, La0.3Sr0.7Fe0.7Cr0.3O3−δ (LSFCr-3) was studied in a 3-electrode half-cell configuration in air, pure CO2 and in a 1 : 1 CO2 : CO mixture, over a temperature range of 650–800 °C. A detailed analysis of the impedance (EIS) data, under both open circuit and polarized conditions, as well as the cyclic voltammetry response of LSFCr-3 has shown that it is very active in all of these environments, but with oxygen evolution being somewhat more facile that oxygen reduction, and CO2 reduction more active than CO oxidation. Evidence for a chemical capacitance, associated with the Fe3+/4+ redox process in LSFCr-3, was also obtained from the EIS and CV data in all gas environments.
SiO2-TiO2 thin films for use as fiber optic guiding layers of optical DNA biosensors were fabricated by the sol-gel dip coating technique. The chemical structure and the surface morphology of the films were characterized before immobilization. Single probe DNA strands were immobilized on the surface and the porosity of the films before the hybridization process was measured. Refractive index values of the films were measured using a Metricon 2010 prism coupler. On the surface of each film, 12 different spots were taken for measurement and calculation of the mean refractive index values with their standard deviations. The increased refractive index values after the immobilization of single DNA strands indicated that immobilization was successfully achieved. A further refractive index increase after the hybridization with target single DNA strands showed the possibility of detection of the E. coli O157:H7 EDL933 species using strands of 20-mers (5’-TAATATCGGTTGCGGAGGTG -3’) sequence.
1 February 2019 in Journal of the European Ceramic Society
The long term performance of SOFC with nanocomposite Ni-YSZ anode and LSM-YSZ cathode was reported. The SOFC was prepared by infiltrating polymeric precursors of NiO and LSM from anode and cathode sides respectively. The fuel cell showed relatively high initial performance (0.49 Watt/cm2 at 800°C) for the given electrolyte thickness (∼170 μm). Long term stability tests showed that the power density dropped to 0.41 Watt/cm2 in the first 60 hours of operation in short circuit conditions and no further change in the power density was observed. Low electrode polarization resistance was obtained (∼0.080 Ohm.cm2 for combined anode and cathode at 800°C) which showed no significant change with prolonged time. The slight drop in power density was related to the change in ohmic resistance which was attributed to the increase in current collection resistance. The fact that the majority of the resistance was due to the electrolyte resistance (∼80%) suggests that stable SOFCs with high power densities could be achieved with thinner electrolytes. After >100 hours of operation at 800°C in short circuit conditions, the fuel cell was measured at higher temperatures. Power densities were 0.71 Watt/cm2 and 1.0 Watt/cm2 at 900°C and 1000°C, respectively.
22 January 2022 in International Journal of Hydrogen Energy