Sm0.2Ce0.8O1.9‐ 30% Na2CO3 (Sm doped ceria (SDC)‐30N) nano‐composite electrolytes were densified in a single step via cold sintering process (CSP). At 200°C and 450 MPa of uniaxial pressure, samples up to 97% of their theoretical density could be obtained. The effect of processing parameters, such as temperature, uniaxial pressure, processing duration, and moisture content, on the densification of the nano‐composite electrolytes was investigated. The thermal, microstructural, and electrical properties of nano‐composites were investigated by differential scanning calorimetry, X‐ray diffractometer, scanning electron microscope, and EIS analysis. SDC crystallite sizes were found to be around 25 nm, barely coarsened after CSP by which the true nano nature of the nano‐composite could be preserved. Because, by conventional processing high density values could not be attained and high processing temperatures in excess of 600°C had to be used, promoting particle coarsening. The highest total electrical conductivity was found to be 2.2 × 10−2 S cm−1 at 600°C, with an activation energy of 0.83 eV for SDC‐30N nano‐composites. The present investigation revealed that the implementation of cold sintering technique resulted in significant enhancements in the densification of nano‐composite electrolytes, thereby rendering them suitable for efficient utilization in SOFC applications, as compared to the conventional production methods.
23 March 2015 in Journal of the American Ceramic Society
Al2O3/Ni and Al2O3/Co nanopowder mixtures (with 3 vol.% of metallic phase) were synthesized by heterogeneous precipitation method. In order to increase the green strength, polypropylene carbonate (PPC) was used as a binder while preparing green compacts. Uniaxially pressed powder mixtures were sintered at 1550°C for 2 h in a reducing atmosphere. The effects of Ni and Co nanophases on the microstructure and mechanical properties of Al2O3 ceramics were studied by X-ray diffraction, scanning electron microscopy, Vickers indentation technique and three-point bending tests. The metallic phase hindered the densification of alumina matrix, yet hardness values of Al2O3, Al2O3/Ni, and Al2O3/Co composites were comparable. Vickers fracture toughness results indicate that the composites have higher fracture toughness, but the characteristic flexural strength and Weibull modulus are higher for the pure Al2O3.
13 February 2009 in Journal of the American Ceramic Society
There has been a long‐standing question about the effect of the type of ionic species on the surface forces that is not considered in the classical Derjaguin–Landau–Vervey–Overbeek theory. Originating from the work of Hofmeister, the ion‐specific interaction between particles has been known for a long time. Depending on the pH and oxide type, a direct or a reverse Hofmeister effect has been observed in colloidal suspensions at high salt concentrations. The origin of this effect is not well understood but is qualitatively taken into account in colloid science. From macroscopic behavior, it is predicted that alumina particles in LiCl solution attract each other more strongly than in CsCl solutions. If such an effect does exist, then force curves obtained using the colloid probe technique may detect the difference. Using chloride salts of the two end members of the Hofmeister series, namely Li
+
and Cs
+
, stronger attraction in the LiCl electrolyte solution compared with the CsCl one was measured for the first time at the microlevel between alumina surfaces at pH=11.