Ünsal Ünver

Dr. Ünsal Ünver

orcid

Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 August 2026 in Journal of the American Ceramic Society
Verified
Journal Article
Open access
PDF file
SBSelma Nur Büyükgöz
Selma Nur Büyükgöz
SPSorour Semsari Parapari
Sorour Semsari Parapari
SŠSašo Šturm
Sašo Šturm
ÜÜÜnsal Ünver
Ünsal Ünver
ABAligul Buyukaksoy
Aligul Buyukaksoy
To increase the ionic conductivity of the conventional solid oxide cell (SOC) electrolyte, yttria stabilized zirconia (YSZ), we propose to fabricate yttria‐doped bismuth oxide—YSZ (YDB–YSZ) composite electrolytes by infiltrating liquid YDB precursor into porous YSZ scaffolds, followed by a heat treatment step. Comparing YDB–YSZ electrolytes fabricated via co‐sintering of the respective powders and those by infiltration, after heat treatment at the same temperature, the latter consisted of monoclinic zirconia and cubic YSZ phases, yielding electrical conductivities even lower than the conventional YSZ. Meanwhile, YDB–YSZ fabricated via infiltration yielded an interconnected network of ionically conductive tetragonal bismuth oxide phase within the cubic YSZ matrix. Consequently, electrical conductivities ca. 2.5 times that of the single‐phase YSZ was determined. The results obtained here suggest that YDB–YSZ composites are promising alternatives to single‐phase YSZ as SOC electrolytes and infiltration is preferable to fabricate these composite SOC electrolytes over the powder‐co‐sintering route.

9 April 2026 in Energies
Verified
Journal Article
Open access
PDF file
BBBuse Bilbey
Buse Bilbey
ASAxel Savikko
Axel Savikko
ÜÜÜnsal Ünver
Ünsal Ünver
MMMurat Murutoglu
Murat Murutoglu
ABAligul Buyukaksoy
Aligul Buyukaksoy
MAMuhammad Imran Asghar
Muhammad Imran Asghar
In this study, commercial Ospray-2507 super-duplex stainless steel powder was investigated for the first time as a potential metal support material for solid oxide cells. Initially, metal supports were fabricated and processed in air using various sintering profiles, followed by comprehensive mechanical, structural and electrochemical characterization. The optimal sintering condition was identified as 900 °C for 5 h. Subsequently, sintering under a H2 atmosphere was explored, and its effects on the microstructural and functional properties of the metal supports were systematically to assessed to evaluate the influence of the sintering atmosphere on material performance. Although X-ray diffraction patterns showed no phase changes between the two sintering atmospheres, notable improvements were observed in mechanical, electrochemical, and microstructural properties under H2 sintering. XPS spectra reveal that both air- and hydrogen-treated surfaces remain rich in chromium (Cr) and Manganese (Mn), which together dominate the surface and consequently attenuate the signal from the underlying iron. The thickness of the Cr- and Mn-based oxide layer decreases when sintering MS in H2 atmosphere. Specifically, mechanical strength, as measured by three-point bending tests, increased by a factor of 12.5, and hardness rose from 500.3 to 523.5 HV. Furthermore, electrical conductivity also improved significantly, exhibiting an approximately 2.3–2.4 fold increase under H2-sintered conditions.