Hydrogen gas is a crucial fuel for the green energy transition as its combustion yields energy and water. However, it is mainly produced through fossil fuels, hindering its potential for environmental benefits. Therefore, the trend is shifting toward green hydrogen produced through renewable sources. Electrolysis by solid oxide electrolysis cells (SOECs) is one of the most promising methods for green hydrogen production due to its high efficiency and chemical conversion flexibility. In addition to producing hydrogen and oxygen by steam electrolysis, SOECs can also produce other electro‐fuels such as syngas and ammonia by co‐electrolysis of steam and carbon dioxide and co‐electrolysis of steam and air, respectively. Conventional SOECs utilize oxide ionic conductor ceramic electrolytes such as zirconia; however, proton‐conducting ceramic electrolytes have recently emerged due to their efficient electrochemical cell designs and improved performance at low operating temperatures. This review presents the status of the oxide ion conductor (SOEC) and proton conductor (PCEC) cell configurations. For this purpose, we summarize the most used materials, fabrication methods, and characterization techniques. Furthermore, we critically investigated the issues related to cell performance and stability by performing a systematic analysis of the degradation mechanisms for both oxide ion conductor and proton conductor electrolysis cells. The recommendations provided in this work would help researchers identify the key issues hindering the commercialization of promising SOEC technology.
Metal-supported solid oxide fuel cells (MS-SOFCs) have recently emerged as a promising configuration to reduce material costs and increase the mechanical robustness of solid oxide technologies.
The most widely used solid oxide fuel cell (SOFC) anodes, nickel-yttria stabilized zirconia (NiO-YSZ) composites, are generally fabricated by co-sintering of NiO and YSZ powders. In this study, to achieve a longer triple phase boundary length, these composites were fabricated from powders synthesized via an ethylene glycol-based Pechini method. Polymeric precursors of NiO and YSZ were prepared separately and then mixed, dried and calcined 600, 700 and 800°C for 4 hours, in air. NiO and YSZ crystals with average sizes of 26 and 7 nm, respectively were achieved upon calcination at 600 °C. With increasing heat treatment temperature, both the crystal and agglomerate sizes increased, which, in turn, an increased the anode polarization resistances. Electrochemical activities comparable to or higher than anode prepared by co-sintering of powder mixtures were achieved in the anodes prepared by sintering of the composite powders.
In this study, commercial Ospray-2507 super-duplex stainless steel powder was investigated for the first time as a potential metal support material for solid oxide cells. Initially, metal supports were fabricated and processed in air using various sintering profiles, followed by comprehensive mechanical, structural and electrochemical characterization. The optimal sintering condition was identified as 900 °C for 5 h. Subsequently, sintering under a H2 atmosphere was explored, and its effects on the microstructural and functional properties of the metal supports were systematically to assessed to evaluate the influence of the sintering atmosphere on material performance. Although X-ray diffraction patterns showed no phase changes between the two sintering atmospheres, notable improvements were observed in mechanical, electrochemical, and microstructural properties under H2 sintering. XPS spectra reveal that both air- and hydrogen-treated surfaces remain rich in chromium (Cr) and Manganese (Mn), which together dominate the surface and consequently attenuate the signal from the underlying iron. The thickness of the Cr- and Mn-based oxide layer decreases when sintering MS in H2 atmosphere. Specifically, mechanical strength, as measured by three-point bending tests, increased by a factor of 12.5, and hardness rose from 500.3 to 523.5 HV. Furthermore, electrical conductivity also improved significantly, exhibiting an approximately 2.3–2.4 fold increase under H2-sintered conditions.