The aim of this study is to investigate the influence of different heat inputs on mechanical properties and microstructure of dissimilar electrical arc welded austenitic stainless steel AISI 304 and low-carbon steel (CS) joints. The mechanical properties of welded austenitic stainless steel type AISI 304 and low-CS are studied. Five different heat inputs 0.5, 0.9, 1.41, 2, and 2.5 KJ/min were applied to investigate the microstructure of the welded zone and mechanical properties. The results showed that the efficiency of the joints and tensile strength increased with increasing heat inputs, while excess heat input reduces the efficiency. Furthermore, changes in microstructure with excess heat input cause failure at the heat-affected zone.
This paper presents a robust dual-loop control strategy for the lateral motion and heading-angle regulation of an autonomous vehicle equipped with a Steer-By-Wire (SBW) system under unknown time-varying disturbances. The proposed framework comprises a fuzzy PID controller in the inner loop to generate the motor torque and track the front-wheel steering angle, and an optimal backstepping controller in the outer loop—integrated with a finite-time disturbance observer—to ensure lateral trajectory tracking and wind-disturbance rejection. The PID gains are tuned online by a Mamdani-type fuzzy inference system, while the backstepping parameters are optimized offline via a genetic algorithm. Beyond the bicycle-model-based design, the controller is evaluated through supplementary simulations using a 6-degree-of-freedom (6-DOF) vehicle model, as well as through a detailed robustness analysis that includes measurement noise and increasing lateral disturbance forces. The results demonstrate that the closed-loop system achieves precise path tracking, finite-time convergence of both tracking and estimation errors, and effective compensation of road vibrations and wind disturbances. Furthermore, the controller maintains stable performance under significant measurement noise and tolerates lateral disturbance forces up to at least 10,000 N without violating safety constraints. The effectiveness of the proposed method is consistently confirmed across both the reduced-order bicycle model and the higher-fidelity 6-DOF validation environment.
20 February 2023 in Al-Nahrain Journal for Engineering Sciences
In this study, the mechanical properties of an epoxy, unidirectional woven carbon and fiberglass composite were investigated experimentally. ASTM used for preparing the composite specimen. Different ranges of mixing ratios of woven carbon and fiberglass with epoxy are studied. Tensile, impact and bending test are carried out to investigate the mechanical properties for produced new composites. After testing the mechanical properties of the specimens, it is noted that adding of unidirectional woven carbon layers will leads to strengthens the samples. The mechanical properties of woven carbon composite are far superior to those of woven carbon composite with fiberglass.