This paper focuses on the nonlinear aeroelastic system identification method based on an artificial neural network (ANN) that uses time-delay and feedback elements. A typical two-dimensional wing section with control surface is modelled to illustrate the proposed identification algorithm. The response of the system, which applies a sine-chirp input signal on the control surface, is computed by time-marching-integration. A time-delay recurrent neural network (TDRNN) is employed and trained to predict the pitch angle of the system. The chirp and sine excitation signals are used to verify the identified system. Estimation results of the trained neural network are compared with numerical simulation values. Two types of structural nonlinearity are studied, cubic-spring and friction. The results indicate that the TDRNN can approach the nonlinear aeroelastic system exactly.
The dynamic stall at high angle of attack is an important aerodynamic problem faced by aircraft, and it has always been a hotspot of aerodynamic research. The traditional reduced order model (ROM) methods needs to establish an accurate model, and has a high demand for experience. In this paper, a novel nonlinear aerodynamic identification method based on recurrent neural networks (RNNs) is proposed. The computational fluid dynamics (CFD) method is used to calculate the unsteady aerodynamic parameters of the NACA0012 airfoil. A group of sinusoidal chirp signals with variable amplitude and frequency are adopted as the excitation signals, and the obtained data are used to train the recurrent neural networks, and the ROM of the nonlinear aerodynamic model of high angle of attack dynamic stall is obtained. Finally, the aerodynamic parameters of a group of composite sinusoidal motion signals different from the training signals are predicted by the trained neural networks model and compared with the CFD results.
22 April 2021 in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
This article presents a fuzzy control method for the limit cycle oscillation (LCO) suppression of nonlinear aeroelastic systems based on the neural network identification algorithm. A prototypical 2D wing section with a single control surface at the trailing edge of the main wing, which contains a symmetrical free play nonlinearity in the pitch degree of freedom, is modeled to illustrate the proposed method. A neural network is used to identify the fuzzy control rules from the existing LCO suppression input and output data. A new fuzzy control rate of the nonlinear aeroelastic system is obtained by adjusting the parameters of the fuzzy control surface. Numerical simulations are conducted to verify the effectiveness of the proposed method.
The dynamic stress caused by vibration when construction hoist is working may cause the structure damage, so the dynamic analysis is an essential part in the design of construction hoist. This paper establishes a dynamic model of construction hoist by ANSYS, then conducts modal analysis, and gets the first 6 natural frequency and vibration modes.