This paper presents a study on evaluating the effectiveness of nanofluid Minimum Quantity Lubrication (NF MQL) in machining Hastelloy C276 alloy—a difficult-to-cut material. The study compares NF MQL using different types of nanoparticles (Al2O3, MoS2, SiC, and GrP) with dry and pure MQL conditions in terms of surface roughness, cutting force components, and especially the variation of cutting forces over time. Experimental results indicate that the graphene-containing nanofluid MQL showed the most superior performance in terms of surface roughness Ra with 54.3% and 34% reduction, followed by MoS2 and Al2O3 nanofluid MQL conditions. Regarding the active cutting force Fa, Al2O3 nanofluid MQL achieves the largest reduction of about 18.4% and 22.1% when compared to dry and pure MQL, followed by GrP nanofluid MQL, MoS2 nanofluid MQL, and then SiC nanofluid MQL. Meanwhile, GrP nanofluid MQL shows the highest percentage of Fz reduction at about 13.4% and 26% when compared to the dry and pure MQL conditions, followed by MoS2 nanofluid MQL. Furthermore, the application of NF MQL also significantly improves tool life and extends about 36.4 ÷ 61.1% and 18.2 ÷ 50% compared to dry and pure MQL, respectively. Notably, through in-depth analysis of the variation of cutting forces, the study has elucidated the superior lubrication and cooling mechanism of the NF MQL method, confirming its potential application in machining advanced materials.
The new technological solutions supporting hard machining processes are becoming an up-to-date research area. The enhancement of cooling lubrication efficiency in the cutting zone plays a crucial role in improving cutting performance. This paper investigates the effectiveness of Minimum Quantity Lubrication (MQL) using SiC nanoparticle-enhanced oil in the hard milling process of AISI D2 tool steel. The results are compared with dry and pure MQL modes based on criteria including cutting force components, surface roughness, tool wear, and tool life. The research results show that compared to dry and pure MQL, the SiC nanofluid MQL environment provides the best performance with reductions in feed force Fx (22.3–23.8%), thrust force Fy (20.5–55.3%), tangential force Fz (26.5–34%), surface roughness (37–62.3%), tool wear (46.1–73.3%), and increased tool life (80–200%). These findings demonstrate that the lubrication and cooling efficiency of the base oil is improved with the addition of SiC nanoparticles. The deep penetration of oil droplets into the cutting zone and the formation of the oil film significantly contributed to reducing friction and cutting heat. SiC nanoparticles not only improved the lubricating and cooling capabilities of the base cutting oil but also created secondary mechanisms within the cutting zone. Furthermore, monitoring cutting forces and surface roughness can be suggested as supplementary criteria for evaluating tool wear and tool life. This research will provide important technological guidance and a theoretical basis for the improvement of hard milling and application of the SiC nanofluid MQL technique.