The 795 nm wavelength corresponds to the D1 transition of rubidium atoms and is widely used in atomic optical pumping, atomic clocks, magnetometers, and precision spectroscopy. For compact free-space collimation, beam shaping, and efficient fiber coupling, edge-emitting semiconductor lasers with reduced fast-axis (vertical) divergence are highly desirable, yet low-divergence designs at 795 nm remain limited. Here, we propose and demonstrate low-divergence photonic-crystal epitaxy (LD–PC) for 795 nm edge-emitting lasers. By engineering a periodic n-side photonic-crystal stack to place the fundamental vertical mode near the photonic band edge, the vertical mode is expanded while maintaining effective modal discrimination. Narrow-ridge Fabry–Pérot lasers based on GaAsP/AlGaAs single-quantum-well epitaxy were fabricated and characterized. The optimized LD–PC device (3 μm ridge width, 1 mm cavity length) delivers 227 mW at 200 mA with a threshold current of 23 mA, a slope efficiency of 1.28 W/A, and a peak wall-plug efficiency of 55% under continuous-wave operation at 25 °C. The measured far-field divergences (FWHMs) are 7.16° and 18.83° in the lateral and vertical directions, respectively, corresponding to a reduction in the vertical divergence from >40° in the reference structure to <20° with LD–PC. These results validate photonic-crystal epitaxy as an effective route toward compact, high-performance, low-divergence 795 nm semiconductor laser sources for rubidium-based atomic systems.
Surface-emitting distributed-feedback (SE-DFB) semiconductor lasers based on second-order gratings face a fundamental triple constraint: the spatial co-location of gain, grating feedback, and vertical radiation functions limits single-mode selectivity, surface extraction efficiency, and far-field beam quality simultaneously. We propose a quasi-parity-time (PT)-symmetric SE-DFB laser with separated gain and radiating-grating sections. In this design, the electrically injected gain section and the passive second-order grating section are placed in different regions along the cavity axis, thereby separating electrical injection from surface emission without epitaxial regrowth. Coupled-mode theory and two-dimensional finite-element simulations demonstrate that the resulting longitudinal non-Hermitian gain–loss asymmetry produces spatial-overlap-dependent threshold discrimination, enabling an isolated low-threshold lasing branch that remains separated from competing cavity modes over the investigated pump-parameter range. Under the HR–AR boundary condition, the proposed design achieves a threshold gain margin of , more than six times that of a conventional HR–AR DFB benchmark considered here, together with an upward surface extraction efficiency of 23.4% obtained from 2D FEM simulations. A simplified steady-state rate-equation estimate further suggests that the increased threshold margin can support strong side-mode suppression. The design imposes no regrowth requirement and is fully compatible with standard single-growth InP ridge-waveguide fabrication.