Many of the research and investigations carried out to replace or reduce the fresh bitumen that uses in pavement construction as a binder due to rising the cost of crude oil production employed in bitumen manufacturing. This research seeks to determine the impact of employing bio-oil, namely waste vegetable oil (WVO), on the properties of bitumen, with the ultimate goal of improving bitumen's performance. The standard tests that were used to evaluate the physical and rheological properties of the control and WVO binders are penetration, softening point, viscosity, loss on heating, and dynamic shear rheometer (DSR). In order to assess WVO effectiveness, two different penetration grades 60/70 and 80/100 asphalt binders were modified with WVO at different percentages (1.5%, 3%, and 4.5% by weight of the binders). According to the results of the tests, the penetration values rose as the quantity of WVO in the binder increased, however, the softening point result decreased as the amount of WVO in the binder increased. With a rise in the amount of WVO in the binder, the viscosity of the binder was reduced. With increasing WVO, the rutting parameter decreased. As a result of this research, it was determined that waste vegetable oil has the potential to affect soft asphalt binders and can be used to make soft asphalt binders. Furthermore, by adding 4.5% WVO to a PEN60/70 asphalt binder, it can become a PEN80/100 asphalt binder.
This work deals with a practical method of using crumb rubber resulting from waste tires to produce modified bitumen via a wet mixing method for road construction in Iraq. Due to wide variation in temperatures and over-loading traffic in Iraq, rutting deformation is the most observed structural pavement problem. Also, tire wear and tear are higher in Iraq than in other countries due to high temperature and dry weather most of the year, which makes considerable amounts of waste tire piles easily accessible. Utilizing this waste material could be crucial to the environment and economy of the country, as well as to the sustainability of resources. Using waste tire materials as bitumen modifiers in the production of hot mix asphalt is a widely practiced experiment, although it is applied differently depending on the weather, type of bitumen used, and its availability. In the methodology of this research, it is suggested to modify asphalt grades 60/70 by a certain amount of crumb rubber (5–20%). The modified asphalt and asphalt grade 40/50 were used in preparing two types of asphalt concretes to examine their volumetric properties and evaluate their rutting behavior. The results for both mixtures were compared to the Iraqi General Specifications for Roads and Bridges (SORB/R9). The findings showed significant improvements in Marshall stability and flow, as well as in the percentages of voids satisfied in the modified mixture. After using rubberized asphalt in the mixture, the rutting depth was recorded below 20 mm and decreased by 30% and 26% at temperatures of 40 °C and 60 °C, respectively, compared to the controlled mixture.
Concrete has a low thermal resistance value, but it is also not a good insulator. The thermal resistance of a material is defined as a measure of the material's ability to resist heat flow from one side to the other. As a result of this property, when the outside temperature increases, the concrete absorbs the heat and retains it, and loses it slowly when the temperature decreases. When a fire occurs in a concrete structure, the temperature of the concrete begins to rise without the possibility of losing the heat gained, when the fire continues for a long time, the structural member fails due to the failure of the concrete. In this study, the parameters considered are the compressive strength of the concrete, the duration of the fire, the grade of compressive strength, and the fire-extinguishing technique. Three grades of concrete M25, M30, and M35 were subjected to temperatures of 300 °C, 600 °C, and 900 °C for one hour and tested after cooling down once by water and the other in air to determine the affectedness the compressive strength of the concrete. The result showed a decrease in compression strength of concrete with varying percentages (10.9 -76.5) % during sudden cooling with water, and (19.4-82) % during progressive cooling in the air.
9 February 2026 in Innovative Infrastructure Solutions