2D MXene Ti3C2T2 (T=F, O, OH) are employed to serve as electrode for 2D SiC through van der Waals interaction. The Schottky barrier height of contacts can be tuned by changing the functional T group of Ti3C2T2 and applying biaxial strain.
We propose a low-temperature electron cyclotron resonance microwave hydrogen-nitrogen mixed plasma treatment method for passivating 4H-SiC surface and investigate the effects of treatment on the structural, chemical, and electronic properties of the surface. The results indicate that the method is highly controllable and could result in an atomically ordered, unreconstructed, smooth, and clean SiC surface. The absence of surface band bending is indicative of an electronically passivated SiC surface with a surface state density as low as 5.47 × 1010 cm−2. This effect could be attributed to the simultaneous effects of H and N passivating on SiC surface.
We have investigated the barrier modulation of an electrically homogeneous Ni/p-type 4H-SiC contact by intercalation of a thin insulator TiO2 layer. It is found that the TiO2 layer can provide an extra barrier increase, resulting into the barrier height at the interface exceeding the Schottky–Mott limit. However, the barrier is inhomogeneous and Gaussianly distributed over the contact area. The barrier inhomogeneity may be due to an increase in interface states density caused by the oxide induced traps. The increase in barrier height is believed to originate from an electrostatic potential increase across the dipole layer related to the induced positive polarization charges on the p-type 4H-SiC surface.
Due to the difficulty of forming a low Schottky barrier at the interface of a metal/SiC contact, preparing Ohmic contacts is still a key technical problem in developing SiC devices. In this paper, the effects of MoS2 intercalation on the interface properties of metal/SiC (Al, Ag, Ti, Au, and Mg) systems were investigated by first-principles calculation. The calculations show that all the metal/SiC contacts exhibit p-type Schottky contacts with strong Fermi level pinning (FLP) at the interfaces. After inserting a layer of MoS2, the Schottky barrier heights are significantly reduced. All the metal/MoS2/SiC systems are tuned to be n-type Ohmic contacts. By calculating and analyzing electron localization functions, projected band structure, partial density of states, and planar-averaged charge density difference, the Ohmic contact formation mechanism may be due to the saturation of dangling bonds of the SiC surface, the reduction in metal-induced gap states, the formation of interface dipole layer, and the shift of FLP position to the interface of metal/MoS2.
1 November 2016 in Japanese Journal of Applied Physics
The barrier and interface states of Ti, Mo, Ni, and Pt contacts to 4H-SiC were investigated. It is found that the barrier heights for all the contacts are Gaussianly distributed and the barrier inhomogeneity varies with the contact metal type. However, the energy-averaged interface states density in the band gap is metal-insensitive. When considering Gaussian distribution, the interface states density extracted from the electrical properties is consistent with the average density of Gaussianly distributed 4H-SiC surface states, indicating that the barrier inhomogeneities at metal/SiC contacts mainly originate from the spatial variation of surface states on SiC surface. The barrier height and barrier inhomogeneity could be modulated by the contact metal, obeying the barrier height theory of Cowley and Sze.