29 March 2023 in ACS Applied Materials & Interfaces
13 May 2019 in Journal of Applied Physics
Near-interface oxide traps severely affect the voltage stability of silicon carbide metal-oxide-semiconductor devices. In this work, electron cyclotron resonance microwave nitrogen plasma and electron cyclotron resonance microwave nitrogen-hydrogen-mixed plasma were used to passivate near-interface oxide traps in silicon carbide metal-oxide-semiconductor capacitors. An improved low-temperature midgap voltage drift method was proposed to evaluate the voltage stability of silicon carbide metal-oxide-semiconductor capacitors. Results showed that the effect of passivating near-interface oxide traps and voltage stability could be improved by increasing the nitrogen passivation time. However, excessive nitrogen passivation created deep-level interface traps that degraded the interface quality, and a small amount of hydrogen could passivate the deep-level traps produced by the excess nitrogen. As a result, the samples subjected to the passivation process with the nitrogen-hydrogen-mixed plasma had a smaller flat-band voltage drift and more stable carbide metal-oxide-semiconductor capacitors than the samples subjected to nitrogen plasma. However, the excessive introduction of hydrogen also produced additional defects, consequently making the stability of the metal-oxide-semiconductor devices sensitive to the time of the passivation process by nitrogen-hydrogen-mixed plasma. Therefore, the suitable time of mixed plasma passivation is crucial to the improvement of the stability of devices.
19 May 2014 in Applied Physics Letters
We propose a low-temperature electron cyclotron resonance microwave hydrogen-nitrogen mixed plasma treatment method for passivating 4H-SiC surface and investigate the effects of treatment on the structural, chemical, and electronic properties of the surface. The results indicate that the method is highly controllable and could result in an atomically ordered, unreconstructed, smooth, and clean SiC surface. The absence of surface band bending is indicative of an electronically passivated SiC surface with a surface state density as low as 5.47 × 1010 cm−2. This effect could be attributed to the simultaneous effects of H and N passivating on SiC surface.
30 March 2012 in Rare Metals
30 May 2013 in Applied Surface Science
2 May 2026 in SSRN Electronic Journal
Among the substrates used for growing β-Ga2O3 thin films, metal substrates have garnered considerable interest because of their excellent thermal conductivity and bottom-electrode function in vertical power devices. Among common metals, Al is an ideal candidate, but how to achieve low-temperature preparation of high-quality Ga2O3 thin films on it and effectively control their properties remains a challenge. In this work, we successfully prepared high-quality polycrystalline β-Ga2O3 thin films on Al substrates using home-built Electron Cyclotron Resonance Plasma-Enhanced Metal Organic Chemical Vapor Deposition (ECR-PEMOCVD) system and systematically compared the comprehensive modulating effects of different post-treatments on the phase, morphology, and defect states of the films. XRD results show that in-situ oxygen annealing reduces the full width at half maximum (FWHM) of the (002) diffraction peak from 0.477° to 0.338°. AFM observations indicate that oxygen plasma treatment (OPT) decreases the surface roughness from 9.37 nm to 6.08 nm. Furthermore, XPS confirms that both in-situ oxygen annealing and OPT can effectively reduce the oxygen vacancy concentration in the films. Then, a metal–semiconductor–metal (MSM) structured deep-ultraviolet photodetector (DUVPD) was fabricated. A photo-to-dark current ratio of 3×103, response times of 0.32 s (rise) and 0.15 s (decay), and a specific detectivity of 2.51×1011 Jones are obtained from the device. These values outperform most Ga2O3 photodetectors on amorphous substrates. This work validates the feasibility of low-temperature $\upbeta$-Ga2O3 vertical power devices on conductive Al substrates, opening a new route for low-cost, high-thermal-conductivity Ga2O3 power electronics.