Predictive diagnosis of motor defects can reduce repair and downtime costs of electrical equipment. This paper presents the results of a research on the effectiveness of the defect classification and recognition system based on convolutional neural network to detect defects in a squirrel-cage induction motor based on the stator supply voltage and output phase currents when supplied from an industrial grid of limited power with possible voltage asymmetry and harmonic distortion taken into account. In this work a simulation model, implemented in MATLAB/Simulink, is proposed to investigate unbalanced conditions. The mathematical model has been verified on a physical test bench and then used to create a database of currents from measured asymmetric grid voltages in the presence of defects such as short circuit between turns of one phase, rotor bar breakage, rotor eccentricity and bearing defects. The classification quality of all defects in the neural network was 72%, with the exclusion of intercoil short circuit defect and the merging of different bearing defects, the quality of the model was achieved 91%. A further increase in the quality of the defect recognition system is due to a building up modification of the neural network architecture.
1 June 2024 in International Journal of Power Electronics and Drive Systems (IJPEDS)
A three-phase four-leg bidirectional power converter used as an input stage of an energy storage system using the inductance (L), capacitance (C), and inductance (L) or LCL filter on the grid side is considered. The article provides a variant of the three-phase four-leg bidirectional converter control system implementation based on 3D space vector pulse-width modulation and per-phase voltage control. A brief analysis of the applied control algorithms of the three-phase four-leg bidirectional converter in inverter and rectifier modes is given. A computer model has been built to investigate the operating modes of the converters of the designated class with both balanced and unbalanced load. Studies were carried out by computer modeling methods in order to optimize the parameters of the LCL filter on the grid side with bidirectional energy exchange. Optimal LCL filter parameters and modulation frequencies are determined for the developed converter, providing acceptable quality indicators when operating in bidirectional mode.
This work contains the results of the research carried out on the framework of the design of the resonant power module of DAB. The peculiarity of this device is that it is supposed to be used as part of the basic element of a scalable power storage system, the load of which is an industrial three-phase network. The paper proposes a method of designing such devices based on preliminary analytical calculations and the development of numerical models. This method includes three stages. In the first iteration, the parameters of the resonant CLLC converter. In the second iteration, in the course of performing more accurate calculations and development of numerical models, the output parameters and the adjustment characteristic of the converter are determined, taking into account the specifics of the load. At the third stage, a numerical model of a high-frequency transformer is developed to determine the number of losses in the core and estimate the values of magnetic induction.
1 December 2025 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This study examines the control and synchronization of an orderly connected network of three-phase bidirectional power converters, serving as the grid interface for an energy storage system. The primary objective is to ensure stable operation under single-phase and non-symmetrical three-phase grid conditions. The control employs independent phase voltage regulation for compatibility. To achieve seamless coordination of an unlimited group of converters, the paper proposes a synchronization method based on a modified Kuramoto model. This method is designed to be compatible with independent phase control during asymmetric grid states. The proposed approach utilizes a structured connection graph, defined by phase shift magnitude, to synchronize the converter group. A brief overview of the tools for synchronizing oscillator groups is provided. A computer model was developed to study the operating modes of this converter class under both symmetrical and asymmetrical loads. Simulation studies confirmed the viability of the synchronization method. Furthermore, the research results were successfully applied in the design and implementation of a physical 10 kW grid - connected uninterruptible power supply prototype, demonstrating practical feasibility.