Groundwater is an important source of water. Since the control and removal of pollution are expensive, it is essential to identify the possible sources of contamination and to correctly classify groundwater on the basis of its intrinsic and integrated vulnerability. In the last years, many fuzzy models have been developed. There is a lack, however, of studies concerning the application of fuzzy logic for the assessment of the susceptibility of groundwater quality to anthropogenic activities and comparing these methods with traditional methods. The fuzzy model described in this paper assesses the aquifer integrated environmental vulnerability connected to the presence of illegal dumpsites and allows us to hierarchically classify them within a hazard scale. The results allowed us to carry out a comparison of the proposed fuzzy method with a traditional method. The fuzzy method proved to be a useful and objective tool for environmental planning.
Dyes are emerging as hazardous pollutants, which are the primary challenges for environmentalists. Dye removal from effluents is urgently needed. Adsorption technology has been widely employed in this context as an effective method for removing colours from the aqueous phase, and adsorption with the use of low-cost adsorbents has been shown to be more successful on a larger scale than other methods. In this study, spent coffee grounds (SCGs) were used as the precursor for the preparation of a low-cost activated carbon through the chemical activation with NaOH. The SCG sample was impregnated with NaOH and carbonised at 300 °C for three hours. Its morphological and physical-chemical properties were assessed using scanning electron microscopy (SEM), X-ray diffraction, and Raman spectroscopy analyses. The performance of the treated SCG as an adsorbent material for methylene blue (MB) was evaluated by analysing the effect of the initial pH ionic strength on the adsorption capacity and by evaluating the kinetics and the mechanisms of the process (using adsorption isotherms). The effect of the initial concentration (500 and 250 mg L−1) of MB on the kinetics of the process and the impact of the initial pH (7.5 and 6) on the adsorption isotherm were evaluated. The obtained results show that the pseudo-second order model controls the process for both the investigated initial concentration and the adsorption capacity, which are 142.8 and 113.6 mg L−1, respectively. The results indicate that the pH value influences the adsorption isotherm model that regulates the process. Specifically, this process is regulated by the Temkin’s model with a pH of 7.5 and by the Langmuir’s model with a pH of 6. The thermodynamics of the process were also determined. The results show that SCG, treated and carbonised by soft alkaline activation, is a promising low-cost adsorbent material as its performance is comparable to that of conventional active carbon materials.
The increasing interest towards climate change, water and energy saving, and soil protection has led the research community to consider non-conventional water as a sustainable source for irrigation of energy crops. Vegetation filter systems are considered a reliable technique for sustainable biomass cultivation, enabling the use of reclaimed wastewater as water and nutrients sources during irrigation periods. In this study, a geographic information system (GIS)-based spatial model was developed to identify areas potentially suitable for creating vegetation filter systems with poplars to size the plants of energy production. An economic assessment allowed us to identify the cost-effectiveness areas for biomass production that can be fertigated by reclaimed wastewater. Considering the Basilicata region as the test region, a surface area of 258,512 ha was investigated, identifying 73,331 ha of SRF soils sited downstream of 45 wastewater treatment plants (WWTPs). However, considering only areas that have positive net present value and are economically attractive, results indicate 1606 ha of SRF falling within the areas of influence of 39 WWTPs. The results show that the sector of dedicated crops, adjacent and linked with WWTPs, expresses a total capacity of 50.56 MW for thermal, 8.25 MW for electricity, and 31 MW for cogeneration (25.07 MWt and 5.94 MWe) plants.
Spent coffee grounds (SCGs) are abundantly produced worldwide as a by-product of coffee brewing, and production is surging following the rise in global coffee consumption. Although the adsorption properties of raw SCGs have been investigated in previous studies, limited attention has been paid to the use of SCG-derived hydrochars as engineered adsorbents. In this work, hydrochars produced via hydrothermal carbonization (HTC) of SCGs at different temperatures were systematically assessed for their capacity to remove methylene blue (MB) dye from aqueous solution. The effect of HTC temperature and soft alkaline activation on MB adsorption were evaluated through adsorption batch tests. The soft alkaline activation increased the experimental adsorption capacity from <20 mg g−1 for untreated hydrochars to approximately 100 mg g−1 at 20 °C, while Langmuir isotherm analysis yielded a monolayer capacity of 147.1 mg g−1 at the same temperature; experimental uptake further increased to 215.6 mg g−1 at 40 °C and high dye concentrations. Kinetic, isotherm, and thermodynamic tests were performed on selected materials to describe their adsorption behavior and potential mechanisms. Microscopic, diffraction, spectroscopic, and porosimetric analyses were performed to investigate the structural differences among the tested materials. This study shows that temperature regulation and soft alkaline activation can strongly improve the adsorption capacity of the hydrochars, producing competitive low-cost adsorbents from a waste material in compliance with the principles of the circular economy.
The growing threat of antimicrobial resistance necessitates alternative strategies to conventional antibiotics. Insects represent a promising source of antimicrobial peptides (AMPs) due to their potent innate immune responses. In this study, we investigated the hemolymph peptide extracts from Hermetia illucens larvae as a bioresource of infection-induced AMPs. Larvae were challenged with Gram-negative (Escherichia coli) and Gram-positive (Micrococcus flavus) bacteria, and hemolymph-derived peptides were extracted and fractionated by RP-HPLC. Peptide fractions were screened in vitro by agar diffusion assay against a panel of pathogenic strains. While extracts from uninfected larvae were essentially inactive, fractions 9–13 from infected larvae showed broad-spectrum antibacterial activity, including against multidrug-resistant clinical isolates such as carbapenem-resistant Klebsiella pneumoniae, suggesting an inducible immune response. Fractions were further analyzed by SDS-PAGE and LC-MS/MS to identify candidate AMPs, while shotgun proteomics on unfractionated extracts enabled quantitative comparison among conditions. Proteomics raw data are available via ProteomeXchange Consortium, with the dataset identifier PXD071144. In silico prediction using ProP 1.0, APD3, and CAMPR4 supported the antimicrobial potential of candidate peptides. Overall, our integrative approach demonstrates that bacterial infection induces a diverse and bioactive immunopeptidome in H. illucens, supporting its potential as a sustainable platform for the discovery of novel antimicrobial agents.
This study investigated the use of microwave (MW) to enhance the performance of a granular thermo-plasma expanded graphite (GTPEG) to remove an organic cationic dye, methylene blue (MB), from freshwater, taking the benefits of MW-assisted regeneration. Expanded graphite (EG), low-density and mesoporous, has been proposed previously as a means of extracting organic compounds from water due to its hydrophobicity and weak polarity. We granularized EG to facilitate its subsequent regeneration and reuse and separation, and MW was used to improve the adsorption of EG. The most important factors affecting adsorption were determined using response surface methodology, along with 3-D graphics illustrating the relationship between several variables. The experimental results show that 94% of MB adsorbed onto MW-GTPEG in deionized distilled water within 20 min. Additionally, adsorbent regeneration using MW did not affect the adsorption capacity and rate after 10 cycles albeit with a small weight loss of <8%. From our results, we believe that the main factor affecting the adsorption was the physical characteristics of the adsorbent, with other minor factors such as the adsorbent dose and initial concentration. Our findings suggest that MW irradiation may be a promising alternative for enhancing and regenerating GTPEG.