Electric ducted fans are gaining prominence in aviation due to their compact size, low noise, and zero emissions compared to conventional gas turbines. This study presents an experimental test system for a 390 mm electric Ducted Propulsion Fan developed by the Aerospace Propulsion Systems group at Hanoi University of Science and Technology. The carbon fiber composite thruster, driven by a centrally located BLDC motor, was mounted on a test stand equipped with force and rotational speed (rpm) sensors. Power was supplied through two battery configurations, eight-pack and nine-pack, with voltage and current monitored and controlled via an ESC module. Experiments conducted from 2000 to 7000 rpm explored the relationship between electrical inputs and aero-propulsive outputs. The results revealed that input power, current, and sound pressure level (SPL) amplified meaningfully with rpm, while the voltage slightly declined. The maximum rpm reached 6500 rpm for the eight-pack and 7000 rpm for the nine-pack configurations. When greater than 6000 rpm, the SPL reaches close to 120 dB. The eight-pack configuration provided higher thrust per volt, whereas the nine-pack offered better thrust per ampere and improved starting power. Although dimensionless indices, including power coefficient (CP), thrust coefficient (CT), and figure of merit (FM), reduced with rpm, the FM remained between 0.7 and 0.75 at medium speeds, demonstrating effective energy conversion.
Electric ducted fans are increasingly being applied in the aviation sector due to their advantages in compact size, low noise, and zero emissions when compared to conventional gas turbine engines. This paper presents a test system for an electric Ducted Propulsion Fan (eDPF) developed by the Aerospace Propulsion Systems group at the School of Mechanical Engineering, Hanoi University of Science and Technology, Vietnam. The core component of the experimental system is a 390 mm diameter eDPF, made of carbon fiber composite and driven by a BLDC electric motor located within the fan core. The eDPF is mounted on a test stand equipped with force sensors and an optical RPM sensor, which are connected to digital display gauges. The power supply consists of LiFePO₄ battery packs, with voltage and current monitored by multimeters and controlled via a potentiometer connected to an ESC module. This electric thruster was experimentally operated at rotational speeds ranging from 2000 rpm to 7000 rpm in order to establish the relationship between its electrical and aero-propulsion characteristics. Initially, the testing aimed to determine the operational thrust range of the eDPF. Subsequently, comparisons were made between the electrical and aero-propulsion performance, as well as dimensionless parameters—including power coefficient (CP), thrust coefficient (CT), and figure of merit (FM)—under two configurations: 8-pack and 9-pack battery setups. In addition, an acoustic test was performed to measure the sound pressure level (SPL) at a distance of 1.0 m. The experimental results provide insights and recommendations for operating the eDPF at different power levels to achieve optimal thrust efficiency.
Accurate and robust representation of moving interfaces remains a challenging issue in numerical simulations of multiphase flows, particularly when the interface is highly curved, under-resolved or undergoes strong deformation. In this study, an improved hybrid one-layer particle level set method is developed for unstructured grids and coupled with a singularity treatment technique to enhance the accuracy and robustness of interface advection. The governing level set equation is discretized using the finite element method providing flexible framework for simulations on general unstructured grids. A one-layer particle approach is employed to compensate for numerical errors introduced during the level set advection and reinitialization, while the singularity treatment addresses localized regions in which the level set representation of interface becomes unreliable due to severe deformation or under resolution. The performance of the proposed method is evaluated through benchmark multiphase flow problems involving significant interface deformation and complex interface topology. The numerical results demonstrate excellent mass conservation and accurate interface representation over a wide range of flow conditions. The method remains robust for highly curved and under-resolved interfaces and retains the geometry flexibility of unstructured finite element meshes.