Thermal infrared (TIR) satellite images are generally employed to retrieve land surface temperature (LST) data in remote sensing. LST data have been widely used in evapotranspiration (ET) estimation based on satellite observations over broad regions, as well as the surface dryness associated with vegetation index. Landsat-8 Operational Land Imager (OLI) and Thermal Infrared Sensor (TIRS) can provide LST data with a 30-m spatial resolution. However, rapid changes in environmental factors, such as temperature, humidity, wind speed, and soil moisture, will affect the dynamics of ET. Therefore, ET estimation needs a high temporal resolution as well as a high spatial resolution for daily, diurnal, or even hourly analysis. A challenge with satellite observations is that higher-spatial-resolution sensors have a lower temporal resolution, and vice versa. Previous studies solved this limitation by developing a spatial and temporal adaptive reflectance fusion model (STARFM) for visible images. In this study, with the primary mechanism (thermal emission) of TIRS, surface emissivity is used in the proposed spatial and temporal adaptive emissivity fusion model (STAEFM) as a modification of the original STARFM for fusing TIR images instead of reflectance. For high a temporal resolution, the advanced Himawari imager (AHI) onboard the Himawari-8 satellite is explored. Thus, Landsat-like TIR images with a 10-minute temporal resolution can be synthesized by fusing TIR images of Himawari-8 AHI and Landsat-8 TIRS. The performance of the STAEFM to retrieve LST was compared with the STARFM and enhanced STARFM (ESTARFM) based on the similarity to the observed Landsat image and differences with air temperature. The peak signal-to-noise ratio (PSNR) value of the STAEFM image is more than 42 dB, while the values for STARFM and ESTARFM images are around 31 and 38 dB, respectively. The differences of LST and air temperature data collected from five meteorological stations are 1.53 °C to 4.93 °C, which are smaller compared with STARFM’s and ESATRFM’s. The examination of the case study showed reasonable results of hourly LST, dryness index, and ET retrieval, indicating significant potential for the proposed STAEFM to provide very-high-spatiotemporal-resolution (30 m every 10 min) TIR images for surface dryness and ET monitoring.
During the unprecedented COVID-19 city lockdown, a unique opportunity arose to dissect the intricate dynamics of urban air quality, focusing on ultrafine particles (UFPs) and volatile organic compounds (VOCs). This study delves into the nuanced interplay between traffic patterns and UFP emissions in a subtropical urban setting during the spring-summer transition of 2021. Leveraging meticulous roadside measurements near a traffic nexus, our investigation unravels the intricate relationship between particle number size distribution (PNSD), VOCs mixing ratios, and detailed vehicle activity metrics. The soft lockdown era, marked by a 20-27% dip in overall traffic yet a surprising surge in early morning motorcycle activity, presented a natural experiment. We observed a consequential shift in the urban aerosol regime: the decrease in primary emissions from traffic substantially amplified the role of aged particles and secondary aerosols. This shift was particularly pronounced under stagnant atmospheric conditions, where reduced dilution exacerbated the influence of alternative emission sources, notably solvent evaporation, and was further accentuated with the resumption of normal traffic flows. A distinct seasonal trend emerged as warmer months approached, with aromatic VOCs such as toluene, ethylbenzene, and xylene not only increasing but also significantly contributing to more frequent particle growth events. These findings spotlight the criticality of targeted strategies at traffic hotspots, especially during periods susceptible to weak atmospheric dilution, to curb UFP and precursor emissions effectively. As we stand at the cusp of widespread vehicle electrification, this study underscores the imperative of a holistic approach to urban air quality management, embracing the complexities of primary emission reductions and the resultant shifts in atmospheric chemistry.
The vertical distribution of aerosols is important for accurate surface PM2.5 retrieval and initial modeling forecasts of air pollution, but the observation of aerosol profiles on the regional scale is usually limited. Therefore, in this study, an approach to aerosol extinction profile fitting is proposed to improve surface PM2.5 retrieval from satellite observations. Owing to the high similarity of the single-peak extinction profile in the distribution pattern, the log-normal distribution is explored for the fitting model based on a decadal dataset (3248 in total) from Micro Pulse LiDAR (MPL) measurements. The logarithmic mean, standard deviation, and the height of peak extinction near-surface (Mode) are manually derived as the references for model construction. Considering the seasonal impacts on the planetary boundary layer height (PBLH), Mode, and the height of the surface layer, the extinction profile is then constructed in terms of the planetary boundary layer height (PBLH) and the total column aerosol optical depth (AOD). A comparison between fitted profiles and in situ measurements showed a high level of consistency in terms of the correlation coefficient (0.8973) and root-mean-square error (0.0415). The satellite AOD is subsequently applied for three-dimensional aerosol extinction, and the good agreement of the extinction coefficient with the PM2.5 within the surface layer indicates the good performance of the proposed fitting approach and the potential of satellite observations for providing accurate PM2.5 data on a regional scale.
Accurate radiometric calibration is essential for high-resolution optical satellite sensors with limited onboard calibration capability, such as the FORMOSAT-5 (FS-5) Remote Sensing Instrument (RSI). The Radiometric Calibration Network (RadCalNet) provides standardized nadir-equivalent surface reflectance for vicarious calibration, but its direct application to off-nadir observations can introduce systematic biases over non-Lambertian surfaces. This study presents a BRDF-corrected vicarious calibration framework for the FS-5 RSI. The framework integrates RadCalNet data with an empirical BRDF lookup table built from in situ multi-angle measurements at Railroad Valley Playa, which is then propagated through 6S radiative transfer simulation. Applied to four FS-5 overpasses, BRDF correction reduced the median relative error of the calibration coefficient from 13–17% to 1–4% across all five spectral bands, providing a quantitative assessment of calibration improvement. The downstream impact was evaluated over an FS-5 La Crau scene. Scene-mean top-of-atmosphere (TOA) reflectance differences across the four multispectral bands ranged from 8.62% (NIR) to 10.99% (Green). The near-infrared reflectance of vegetation (NIRv), a proxy for gross primary production, showed a scene-mean relative difference of 7.88% ± 7.32%, with localized values exceeding 20% in densely vegetated areas. These results establish quantitative calibration-accuracy requirements for sensors relying on vicarious calibration and demonstrate the operational necessity of BRDF correction for reliable TOA reflectance and vegetation product retrieval.
Aerosol type plays a critical role in the relationship between aerosol optical depth (AOD) and particulate matter (PM) mass concentration. Here, we present a mathematical formulation of how PM 2.5 is related to AOD; when simplified to a linear equation, it reveals a functional dependence of the slope on aerosol type, hygroscopic growth, and boundary layer height, while the influence of the vertical aerosol profile is embedded in the intercept. We further employed a daily averaged AERONET measurement training dataset to develop a Normalized Gradient Aerosol Index (NGAI) for classifying sub-aerosol-types: mineral dust (MD), urban-industrial pollution (U/I) and biomass burning (BB). By distinguishing the aerosol subtypes beforehand, the derived AOD-PM 2.5 linear regressions were significantly improved, demonstrating that NGAI can exploit the difference in aerosol hygroscopicity and improve the surface dry PM 2.5 estimations. In addition, the hygroscopic growth factor, f (RH), can be estimated based on the slope (β 1 ) of the AOD-PM 2.5 expression.