The development of a country is affected by various multifaceted factors, which are likely to generate the highest benefits. For example, developing water resources by constructing embankments to store water and for transportation must consider high resilience, particularly with the current challenges arising from climate change. Another factor that must be considered is the shortage of essential materials for embankment cores, such as clay, which is the primary material for constructing such cores. This study aims to analyze the stability of soil embankments between the change of materials, namely clay and asphaltic concrete, by varying the water level and increasing the embankment load. The result shows that the asphaltic concrete core exhibits a significantly higher stability than the clay core, such as its reduced water seepage and lower deformation. In the worst-case scenario, the asphalt concrete core has a thickness of 0.3 m and a seepage rate of 15.1 × 10−4 m3/day. Comparatively, the seepage rate of the clay core is approximately 10-times lower.
This study evaluates the feasibility of using asphalt concrete as an impermeable core material for rockfill dams under tropical conditions. Laboratory testing and numerical modeling were conducted to assess the hydraulic and mechanical performance of asphalt concrete mixtures produced with locally available aggregates in Thailand. Asphalt mixtures were designed using the Marshall method with asphalt binder contents of 6% and 7% and target air void contents between 1-4%. Laboratory testing included permeability testing, Marshall stability testing, and triaxial compression tests to determine hydraulic conductivity, shear strength parameters, and deformation characteristics. Results show that asphalt concrete mixtures with air void contents below 1% exhibit extremely low permeability, with hydraulic conductivity on the order of 10⁻¹¹–10⁻¹² m/s, satisfying requirements for impervious dam cores. Triaxial compression tests yielded cohesion values between 97-572 kPa and friction angles ranging from 31° to 52°, indicating adequate shear resistance. Numerical simulations performed using GeoStudio compared rockfill dams with asphalt concrete cores and conventional clay cores. The results demonstrate that a 0.5‑m‑thick asphalt concrete core provides comparable seepage control and slope stability while requiring significantly smaller material volume. The findings suggest that asphalt concrete cores represent a technically feasible and economically advantageous alternative to clay cores, particularly in regions where suitable clay materials are limited.