Supplementary cementitious materials (SCMs) have been widely used to enhance both the microscopic and macroscopic properties of the Portland cement (PC)–SCM composite matrix. Few studies have been undertaken to establish the gel/space ratio of meta-illite calcined clay (MCC) and rice husk ash (RHA)-based high-performance concrete (HPC) mortar. This experimental paper describes a conventional degree of hydration (non-evaporable water) and porosity routes of establishing a link amid the gel/space ratio and compressive strength of a sieved mortar from Class 1 (50–75 MPa) HPC at an early age. Using the non-evaporable water method, this paper predicted the gel/space ratio of the hardened MCC/RHA-based HPC mortars and curved fitted into Powers’ exponent equation. The results from this study revealed that MCC or RHA additions (5–30% by weight of PC) to the PC-SCM matrix led to a moderate decline in the compressive strength of the low water-binder ratio (W/B) HPC mortar. The modification aimed at void volume (superabsorbent polymers, SAP, and air) applying Bolomey’s formula and Powers’ gel/space ratio developed a suitable fitting into the Powers’ model. This experimental procedure shows feasibility to predict the MCC and RHA outcome on the compressive strength of HPC.

Batching of concrete is generally the proportioning of the different constituents of concrete before mixing which could be by weight or volume. Mix-design justified by trial test is the best method to achieve a concrete of desired properties. Standardized prescribed concrete (SPC) mix-design is mostly adopted in mass concreting to high strength concreting applications in most developing nations. British standards accept volume batching for SPC only in mass concrete (20 MPa) recommended to be batched by weight. Designs batched by volume have been identified as the most commonly used method in concrete production in Nigeria and most developing nations, especially by medium to small scale construction firms due to the very high cost of employing batching plants. This research work developed a modified volumetric batch mix-design that will be equivalent to SPC design mix batched by weight in normal and higher strength concrete. The physical properties of the constituent concrete materials, fine aggregate, 12 and 19 mm sized coarse aggregates were determined. The strength of SPC mix of ST2, ST4, and ST5 to British standard were determined when batched by weight and their volume equivalents mix-design batch determined. The strengths of these SPC mixes were batched by volume and their weight equivalent batch-design determined. A relationship was determined between both batching mix-design methods for all the prescribed mixes and strengths using the binder-aggregate and coarse-fine aggregate ratios, such that the preferred weight batching design mix could be achieved by a modified mix-design batched by volume. This study concludes that concrete mix-design batched by weight is superior to when batched by volume and the desired design batching by weight could be achieved by generating a modified mix-design-batch by volume. This will improve the quality of concrete storey buildings in most developing nations.

Curing, though important is sometimes underrated in concrete production. This dataset provided shows the effects of four (4) different methods of curing on two distinct mix ratios. The data provided in this article are for a study that was conducted on one hundred and sixty (160) cube samples of mix ratios 1:2:4 and 1:1.5:3 while employing four (4) different methods of curing. The data given in the article displays the finding of the study. The findings can aid in prediction and optimization of concrete behavior and compressive strength when any of the curing methods are utilized.