Today, the aviation industry is transitioning from fossil fuel to renewable energy. Re-newable energy systems have advantages, such as cleanliness and reduced emissions, but also face limitations in battery energy density and aerodynamic performance dur-ing operation. Therefore, electric ducted propulsion fans (eDPFs) are a promising so-lution that uses duct components to enhance aerodynamic efficiency and operational safety. This study utilizes average Navier-Stokes analysis, incorporating Reynolds numbers and a k-ω SST turbulence model, to examine eDPF configurations both with and without a secondary air intake channel, concentrating on internal flow dynamics and aerodynamic efficiency. The air intake channel, which is located close to the tip of the rotor blade, helps the eDPF move more mass and create more thrust. Several dif-ferent configurations of the secondary air intake channel were tested by varying the intake channel position, curvature, and size of the inlet and outlet ports under static conditions at 6000 rpm. The best design improved thrust by an additional 2.2% com-pared to the baseline case without the auxiliary intake port
30 September 2026 in International Journal of Marine Science and Technology
Electric ducted propulsion fans (EDPFs) have become a key propulsion technology for next–generation electric aircraft, urban air mobility (UAM) vehicles, and unmanned aerial systems, offering high propulsive efficiency, a compact configuration, and reduced noise emissions. This study presents both numerical and experimental performance evaluations of an EDPF with a rotational speed range from 2,000 to 7,000 rpm. The aerodynamic thrust and torque performance of an EDPF were evaluated using 3D Reynolds–Averaged Navier–Stokes (RANS) simulations with the SST k–ω turbulence model and subsequently validated against experiment. The results showed that the maximum difference between the numerical and experimental thrust at 6,000 rpm was very small with only 0.86%. The peak efficiency of the EDPF reaches 93% at 7,000 rpm. These numerical and experimental results confirm the accuracy of the computational model with RANS and demonstrate its applicability in the performance analysis and optimization of EDPF. With this design, it could be used as a propulsion system for unmanned surface vehicles (USVs) if the rotating drive mechanism is driven by a drive shaft or the electric motor can operate in a water environment.
Ducted propulsion fans are widely recognized for their ability to enhance aerodynamic efficiency and operational safety by utilizing a surrounding shroud to contain the flow and mitigate blade tip losses. However, maximizing thrust and optimizing internal flow dynamics remain critical challenges in further improving their aerodynamic performance. This study investigates the aerodynamic characteristics of a ducted propulsion fan configured with a secondary air intake channel designed to enhance mass flow ingestion. Utilizing Reynolds-Averaged Navier–Stokes (RANS) simulations coupled with the Shear Stress Transport (SST) k-omega turbulence model, the internal flow dynamics and aerodynamic efficiency of configurations both with and without the secondary air intake channel are examined. The secondary air intake, strategically located adjacent to the rotor blade tip, increases the mass flow rate and, consequently, enhances thrust. Physically, this configuration successfully reinjects bypass flow to mitigate tip leakage vortices, significantly reducing the low-velocity wake regions adjacent to the rotor tip. Several configurations were evaluated by systematically varying the intake channel’s position, curvature, and the dimensions of its inlet and outlet ports under static conditions at 6000 rpm. Numerical results demonstrate that the optimal design improves thrust by an additional 2.2% compared to the baseline ducted fan without the auxiliary intake port due to the mitigated tip vortices and stabilized flow field.
9 October 2026 in International Journal of Aeronautical and Space Sciences