Libish Murugesan

Dr. Libish Murugesan

orcid

Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 October 2026 in Sustainability
Verified
Journal Article
Open access
PDF file
AAAmmar Alammar
Ammar Alammar
AAAbdulrahman Alymani
Abdulrahman Alymani
MAMohammed Alsofiani
Mohammed Alsofiani
LMLibish Murugesan
Libish Murugesan
Eshrar LatifEshrar Latif
Eshrar Latif
Phase-change material (PCM) glazing and dynamic external shading are promoted as sustainable cooling measures, yet they act on the same solar load and are rarely assessed together under a mandatory energy code. This study aims to evaluate and compare the individual and combined performance of PCM glazing and adaptive external louvres in reducing cooling demand in a code-compliant office building under present and future hot–arid climates. The reference case is an SBC 601-compliant west-facing Riyadh office under present and 2080 weather. EnergyPlus was coupled with a calibrated one-dimensional enthalpy PCM model using a one-way coupling framework. The approach was verified against a fully bidirectional co-simulation (0.5–1.8%). Adaptive louvres cut annual cooling by 10.2% (71% of the west-glazing share). A matched no-latent control attributes only 0.5 of the 9.4 points saved by PCM glazing to latent storage: the code glazing optically starves the PCM. Their combination is sub-additive by 6.6 percentage points across 21 sensitivity variants. Melt and placement sweeps favour a 35 °C melt point and the outer pane. On thermal grounds, adaptive external louvres should be prioritised for code-compliant hot–arid buildings, while PCM glazing is most beneficial where higher solar gains allow latent heat utilisation, informing sustainable façade codes.

19 November 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
AAAbdulrahman Alymani
Abdulrahman Alymani
LMLibish Murugesan
Libish Murugesan
YAYara Moeid Alenezi
Yara Moeid Alenezi
Infill patterns for load-bearing printed parts are often chosen with little evidence, and a homogenised finite-element model calibrated from the slicer toolpath is the natural screening tool. We measured where such a model stops being reliable, using a topology-optimised Messerschmitt–Bölkow–Blohm beam with cubic, gyroid and honeycomb infill at two densities. The reference is a road-resolved model of every deposited toolpath; no beam was tested mechanically. Three limits appear. First, inputs: skipping arc moves without updating the position inflates the gyroid orientation input in all four slicers tested, and the nominal density setting hides almost all of the pattern difference. Second, the core law: a scalar density law falls 8 to 20% below the reference and loses the difference between cubic and gyroid, while a homogenised tensor removes this error. Third, resolution: with a tensor core and dense material of the correct thickness, stiffness agrees with the reference within 5 to 7%, yet cubic and honeycomb cannot be separated. Omitting the solid layers about halves the stiffness. Weaker bonding between layers keeps the pattern order. These results apply to one beam and to linear elasticity. The data and code are openly available.