PIN-type self-powered deep ultraviolet (DUV) photodetectors (PDs) based on Ta doped n-Ga2O3/i-Ga2O3/p-GaN structures with different i-Ga2O3 layer thicknesses were prepared. In the structure, a Ta element in the doped Ga2O3 epitaxial layer should be substitutional doping, which can be confirmed by time-of-flight secondary ion mass spectrometry. With increasing thickness (0–90 nm) of the i-Ga2O3 layer, the crystal quality of the deposited epitaxial films is gradually improved, but the performance of corresponding PDs does not increase monotonically. The PD with an i-layer thickness of c.30 nm under zero bias shows the best response performance such as maximum photoresponsivity (8.67 A/W), good detectability (1.08 × 1014 Jones), and fast response/decay time (86/50 ms) under 222-nm-UV-light illumination. Such good performance should be attributed to the competition between the high photogenerated carriers and the low electric field, whereas the competition is caused by broadening of the depletion region. This research provides an improved and easy method for fabricating high-performance self-powered DUV PDs.
Amorphous or polycrystalline tantalum pentoxide (Ta2O5) films with high resistance have been widely used in semiconductor devices as insulating dielectric layers. In this work, tungsten (W) doped δ-Ta2O5 (0001) monocrystal films were deposited on Y-stabilized ZrO2 (111) substrates using a pulsed laser deposition system. The lattice structure, heteroepitaxial relationship, and electrical properties of the films were analyzed in detail. The carrier concentration, Hall mobility, and resistivity of the 2% W doped δ-Ta2O5 film are 6.61 × 1015 cm−3, 65.2 cm2/V s and 14.5 Ω cm, respectively. High performance metal–semiconductors–metal ultraviolet (UV) detectors based on the W doped δ-Ta2O5 films were fabricated. The UV detector based on a 2% W doped δ-Ta2O5 film exhibits a high photo responsivity of 10.32 A/W and a photocurrent-to-darkcurrent ratio of 1.3 × 104. The performances of the UV detectors in this work are so high, which indicates that the W doped δ-Ta2O5 films can be applied in UV detectors as an active layer.
5 December 2019 in Journal of the American Ceramic Society
ZnSnO3 single crystal films were prepared on c-plane sapphire substrates using pulsed laser deposition and post-annealing methods. For the as-grown sample at 700 °C, post-annealing at 700 °C resulted in a significant improvement in the crystalline quality of the single crystal films, while post-annealing at 800 °C led to decomposition of ZnSnO3. Compared with the amorphous and mixed crystal ZnSnO3-based photodetectors (PDs), the single crystal ZnSnO3-based PD has a better light-to-dark current ratio (1.32 × 106) and higher responsivity (8.71 A/W) at 5 V under 254-nm UV (1.1 mW/cm2) illumination. Such a good performance serves as resounding validation of the remarkable potential of ZnSnO3 epitaxial films in the context of solar-blind PDs.