21 August 2023 in Applied Physics Letters
PIN-type self-powered deep ultraviolet (DUV) photodetectors (PDs) based on Ta doped n-Ga2O3/i-Ga2O3/p-GaN structures with different i-Ga2O3 layer thicknesses were prepared. In the structure, a Ta element in the doped Ga2O3 epitaxial layer should be substitutional doping, which can be confirmed by time-of-flight secondary ion mass spectrometry. With increasing thickness (0–90 nm) of the i-Ga2O3 layer, the crystal quality of the deposited epitaxial films is gradually improved, but the performance of corresponding PDs does not increase monotonically. The PD with an i-layer thickness of c.30 nm under zero bias shows the best response performance such as maximum photoresponsivity (8.67 A/W), good detectability (1.08 × 1014 Jones), and fast response/decay time (86/50 ms) under 222-nm-UV-light illumination. Such good performance should be attributed to the competition between the high photogenerated carriers and the low electric field, whereas the competition is caused by broadening of the depletion region. This research provides an improved and easy method for fabricating high-performance self-powered DUV PDs.
18 March 2024 in Applied Physics Letters
ZnSnO3 single crystal films were prepared on c-plane sapphire substrates using pulsed laser deposition and post-annealing methods. For the as-grown sample at 700 °C, post-annealing at 700 °C resulted in a significant improvement in the crystalline quality of the single crystal films, while post-annealing at 800 °C led to decomposition of ZnSnO3. Compared with the amorphous and mixed crystal ZnSnO3-based photodetectors (PDs), the single crystal ZnSnO3-based PD has a better light-to-dark current ratio (1.32 × 106) and higher responsivity (8.71 A/W) at 5 V under 254-nm UV (1.1 mW/cm2) illumination. Such a good performance serves as resounding validation of the remarkable potential of ZnSnO3 epitaxial films in the context of solar-blind PDs.
13 July 2023 in Applied Surface Science
8 December 2025 in Applied Physics Letters
This work reports the zirconium-doped indium oxide (IZRO) transparent conductive thin films on infrared optical quartz glass (JGS-3) substrates via room-temperature RF magnetron sputtering. The effects of annealing temperature and oxygen flow ratio on electrical and optical properties were systematically investigated. The optimized IZRO film with 3 sccm oxygen flow and 700 °C annealing temperatures exhibited an average optical transmittance of 91.5% in the wavelength of 1300–1550 nm and a minimum resistivity of 1.37 × 10−3 Ω·cm with a carrier concentration of 2.46 × 1020 cm−3. The results of x-ray photoelectron spectroscopy revealed that the enhanced electrical conductivity can be attributed to the activation of Zr doping through high-temperature annealing. Meanwhile, the structural and morphological properties of the obtained films were investigated in detail. The IZRO films have potential in the field of short-wave infrared (SWIR) optoelectronic devices due to their SWIR transparent conductive properties.
5 March 2026 in SSRN Electronic Journal
The attractive properties of zinc germanate (Zn2GeO4), including a wide bandgap and high chemical stability, make it promising for ultraviolet (UV) photodetection. However, the impact of its crystallization state on device performance remains underexplored. In this work, metal-semiconductor-metal (MSM)-structured photodetectors were fabricated based on amorphous and crystalline willemite-type Zn2GeO4 thin films. The crystalline detector exhibited superior temporal response: under 8 V bias and 235 nm illumination, its rise time and decay time were 1.14 s and 44 ms, respectively, significantly faster than those of the amorphous counterpart (4.92 s and >10 s). The crystalline device also showed lower dark current (8.2 pA vs. 98.7 nA) and better wavelength selectivity in the UV-C range. These improvements are attributed to reduced defect density and enhanced carrier transport in the crystalline phase. This study demonstrates that crystallization engineering is an effective strategy for optimizing the performance of Zn2GeO4-based UV photodetectors.