In this study, we numerically investigated the effects of CO2 gas in geothermal water and the scale deposition formed in the wellbore on the flow characteristics. Geothermal water that contains CO2 gas has the potential to produce calcite scale deposits in the wellbore. To prevent scale formation, scale inhibitor is injected below the flash point in the wellbore, which is a challenging job. Therefore, using a wellbore simulator to predict the depth of flash commencement and the effects of scale deposition above the flash point on flow characteristics is important. In our numerical simulations, we changed the values of the CO2 gas concentration to study its effect on the flow characteristics. The simulation results show that the presence of CO2 increases the flash pressure relative to that of pure water. A higher CO2 gas concentration in the water will initiate flashing at a lower depth than a lower CO2 concentration. However, when the presence of scale deposits in the wellbore is taken into account, the calculated wellhead pressure is lower than that in a wellbore without scale deposition.
This study aims to determine the phenomena of water and oil separation and the performance of the Liquid-Liquid Cylindrical Cyclone (LLCC). The experiments were conducted with water and oil in a transparent LLCC separator that allows the visualization of the mixture. Series of experiments for various of inlet mixture velocity (Vm), inlet oil volume fraction (α), and split-ratio have been performed. Volume fraction of oil in the inlet were 0.06 (6 %), 0.1 (10%), and 0.15 (15 %). The examined inlet mixture velocity variations were 1.0 m / s, 1.5 m / s, and 2.0 m / s. Split-ratio was made in the range 25-70 %. The watercut in underflow were the variables measured. The experimental results show that the LLCC was able to separate water and oil and produced free water with concentration up to 98%. By increasing the value of the split-ratio, watercut in underflow increase and reached the optimum point. Optimal split-ratio observed is between 60 % and 70 % depend on the inlet oil volume fraction.