Eye-tracking technologies enable precise measurement of eye movements and are widely used in visual behavior analysis and biomedical engineering applications. Oculomotor parameters, such as fixation duration, saccades, and pupil dilation, are influenced by both visual stimulus characteristics and emotional state; however, the relationships between these factors are difficult to model in a coherent manner. In this context, this paper proposes a model for describing the influence of wavelength and emotional parameters on eye movements. The model expresses oculomotor parameters as functions of the input variables, using simplified relationships that allow both interpretability and practical implementation. To analyze the model, a MATLAB-based application was developed, enabling the simulation of oculomotor behavior under different scenarios. The obtained results highlight variations in the analyzed parameters depending on the input conditions and support the applicability of the model in biomedical monitoring and visual behavior assessment.
This paper describes the design, fabrication, and successful evaluation of a wristband developed for alerting users in critical situations. The target group is single people, especially the elderly, but also people with various disabilities. A low-cost wristband, which, when these people fall, immediately triggers a Wi-Fi-connected alert system on the gadgets of the staff or the person belonging to them. The system is implemented as a wearable forearm sleeve that integrates multiple sensors and electronic components, capable of sending instant alerts to family members or caregivers via the Blynk application.
The paper presents a research stage, within PhD Thesis, focused on critical analysis of the solutions for quality insurance in the production activity, standpoint dimensional inspection. The key was the programming of a flexible and efficient software environment, which will help the operator to make the proper decision on the best method and optimal means of dimensional measurement of various categories of fabricated components. It is practical one and it could be very important for productivity increasing, for low costs and also for finite products high quality. To accomplish this software application it were defined as inputs several criteria, like: inspection process timing, measuring precision, devices costs, process costs and energetic consumption. The most part of these criteria (process duration, measuring precision, devices costs) was possible to be established very properly, due to some previous analytical and empiric results, associated to several tested measuring devices