This article presents a voltage-stacked energy-recycling switched-capacitor (ERSC) boost converter for biasing single-photon avalanche diodes (SPADs) used in LiDAR systems. The boost converter used in such systems must maintain high efficiency while providing a wide output voltage range to cover the wide system dynamic range and the temperature-sensitive variation of the SPADs breakdown voltage. To these challenges using a single 5V input supply, the proposed converter employs a 1/2x ERSC stage to reduce the effective dropout voltage of the linear voltage regulator (LVR) while recycling the residual energy back to the input, thereby improving overall efficiency and extending the achievable output voltage range. In addition, an advanced continuous pole-tracking compensation technique is introduced to maintain a stable phase margin across wide output voltage and load current ranges. Measurement results show that the fabricated prototype achieves an output voltage range of 14-19 V, corresponding to a voltage conversion ratio of 2.8–3.8x. The converter attains a peak efficiency of 95%, output voltage recovery times of 240 ns and 280 ns for 220 mA load step-up and step-down events, respectively, and a maximum steady-state output ripple of 10 mV.
This paper presents a dual-output high-step-down buck converter with a resonant charge redistribution output stage using an average-difference regulation (ADR) scheme. The proposed converter combines a double-step-down (DSD) power stage and a resonant switched-capacitor charge redistribution (RCR) output stage to generate two low-voltage outputs from a 12 V input. The DSD stage regulates the intermediate voltage, which determines the sum of the two output voltages, while the RCR output stage controls the voltage difference between the two outputs through phase-shift control. Therefore, the proposed architecture separates output-voltage average regulation and output-voltage balancing, reducing cross regulation under load-imbalance conditions. The converter was designed in a 0.18 m BCD process with an active chip area of , including bonding pads. It supports two output voltages from 0.8 V to 1.2 V with a maximum load current of 2 A per output. Simulation results show an output voltage ripple of 7 mV at 1 V. For a 0.5 A to 2 A load step, the transient output exhibits a 147 mV undershoot, while the cross-regulation voltage is limited to 18 mV. The peak efficiency is 90.1% at a 0.5 A load current per output.