We present a materials analysis platform that extracts fundamental material parameters from experimental data via interpretable machine learning. This platform is adaptable to other materials/experiments and is implementable on desktop computers.
A controlled amount of excess lead iodide (PbI2) in the perovskite precursor has been widely used in perovskite solar cells (PSCs) to enhance the device's performance by passivating defects. However, an excessive amount of PbI2 can lead to significant hysteresis and reduced stability. Managing the excess PbI2 in the perovskite bulk and on the top (exposed) surface is achievable, but the bottom surface presents a challenge. This study offers a method for adjusting the amount of excess PbI2 in perovskite solar cells at both the bottom surface and the bulk of the perovskite layer. This treatment, known as buried interface modification, is effective for both negative-intrinsic-positive (n-i-p) and positive-intrinsic-negative (p-i-n) structures, achieving efficiencies of 25.9% and 24.6%, respectively, with negligible hysteresis and excellent stability of over 1000 hours under light at the maximum power point.
In perovskite solar cells (PSCs), a common characteristic of highly effective interface passivation materials is low conductivity. Gains in voltage are thus often disproportionately offset by resistive losses. Local contact approaches can minimize this trade‐off and have a proven track record in conventional silicon photovoltaics. Indeed, recent record efficiencies for centimeter‐scale PSCs exploit architectures where the passivation layer partially covers the perovskite‐transport layer interface. Herein, a three‐dimensional numerical device model is used to determine practical performance limits to local contact geometries and consider both the optimum contact dimensions and the trade‐offs involved in relaxing these dimensions for ease of fabrication. It is observed that the potential for substantial power conversion efficiency (PCE) increases with local contacts. In devices where power loss occurs solely through recombination at the contacted interface, PCE can be enhanced by up to 10% absolute compared to a full‐area contact. However, optimum PCEs depend on contacts on the order of nanometers. It is shown that more fabrication‐friendly micrometer‐scale contacts still boost PCE, but the absolute enhancement falls short due to the relatively low bulk perovskite charge carrier diffusion length. This may ultimately motivate methods of interface engineering that produce “effective” local contact geometries at nanometer scales, such as via self‐forming layers.
We investigate BA2MAPb2I7 (BAMA) quasi-2D Ruddlesden–Popper perovskite thin films prepared through single-crystal-derived and conventional polycrystalline routes. Morphological and X-ray diffraction analyses reveal significant differences in film texture, crystallinity, and phase distribution. Steady-state and time-resolved optical spectroscopies show that polycrystalline films are mainly composed of n = 2 and n = 3 phases and exhibit limited interphase energy transfer. In contrast, single-crystal-derived films display a richer excitonic landscape characterized by the presence of higher-(n) domains. Transient photoluminescence and pump–probe measurements demonstrate that the n = 2 exciton acts as the primary donor state and, uniquely in the single-crystal-derived films, undergoes two distinct transfer processes on the same timescale. The correlation between the decay of the n = 2 exciton and the population of lower-energy excitonic states provides direct evidence of hierarchical exciton funneling. These findings highlight the crucial role of phase distribution and crystallinity in governing exciton migration and energy-transfer pathways in low-dimensional perovskite heterostructures.