We present an arrayed waveguide dynamic gain equalization filter with less than 4.5-dB insertion loss and greater than 14-dB dynamic range over the C-band resulting from three improvements: a circulator and polarization splitter combined into one, used to make the device polarization insensitive; segmentation in the star coupler transition regions; and an exponential control wavelength distribution.
We demonstrate a 60-km CWDM-TDM PON with 40 Gb/s capacity both down and upstream. The system incorporates technologies such as volume manufacturable transmitters, burst-mode transmission, hybrid SOA-Raman amplifiers, and a cyclic CWDM multiplexer.
We report progress on fully integrated variable optical attenuator multiplexers (VMUXs). We show substantial performance improvements, notably very low loss and PDL, and the realization of extremely compact designs in high delta silica-on-silicon.
This paper investigates a parallel multilevel current source inverter (CSI) for low-voltage to medium-voltage (LV/MV) photovoltaic (PV) power conversion based on 3.3 kV SiC MOSFET and dedicated space vector modulation (SVM) schemes. A design-oriented sizing tool is developed to evaluate semiconductor losses, junction temperatures, and conversion efficiency across the full maximum power point voltage () range (≈850–1450 V) of a open-circuit voltage () PV string for three-, five-, and seven-level configurations, accounting for synchronous rectification mode (SRM) constraints, whereas experimental validation was performed exclusively on a two-block (five-level) prototype. Numerical analysis demonstrates that power building block shedding (PBBS), i.e., the sequential activation of parallel CSI matrices, improves European efficiency by approximately 0.19% in this specific configuration compared to the defined seven-level operation while maintaining device junction temperatures within acceptable thermal limits. A CL output filter is sized to target WTHD below 3% over the operating envelope. A two-block (five-level) prototype demonstrates LV/MV conversion up to approximately 4.2 kW, validating the proposed SVM sequence. Since experimental operation was conducted under worst-case conduction losses (non-SRM) due to testbench safety constraints, a full performance evaluation could not be completed at this stage.