In tunnel smooth blasting, optimizing the water interval charging structure of peripheral holes is of great significance in improving the effect of smooth blasting and reducing the unit consumption of explosives. Addressing the issue of a single traditional evaluation standard, this paper proposes a composite index evaluation method for rock blasting damage in different zones, and the best charging structure is optimized according to the evaluation results. Taking Liyue Road Tunnel Light Smooth Blasting Project in Chongqing as the Research Background, the numeric models were established with ten kinds of charge structures, the charge structures and explosive quantity were optimized according to the evaluation results, and then the field tests were conducted. The results show that when the length of the water medium at the bottom of the hole is 20 cm, the damage range of the retained rock mass can be controlled while ensuring rock fragmentation. If the length of the water medium at the orifice and in the center of the hole is more than 30 cm, it will affect the superposition effect of the blast stress wave, resulting in under-excavation; in the preferred charge structure, the ratio of the length of the upper and lower explosives reaches 1:3, and the ratio of the length of the water medium is 2:2:1, which achieves a better rock-breaking effect in the field test.
Different types of deep-hole blasting techniques are needed to solve gas drainage problems in complex and variable cases. Blasting parameters suitable for mines are selected based on the relationship between blast stress field changes and gas flow combined with field application and numerical simulation. The Datong Mine was a background to study the blast crush zone and drainage influence range following deep-hole blasting with holes laid in coal seams, which resulted in a 24% increase in gas flow in the drainage hole 6 m from the blast hole. In response to the difficulty of forming blast holes in the soft coal seam of the Yuyang Mine, drilling and blasting in the floor rock stratum adjacent to the coal seam increased the gas flow in the drainage holes by 125%. When applying the deep-hole technique with holes crossing multi-seams for gas drainage in Shiping Mine, the volume of gas drainage increases significantly with increased effective stress in the drainage hole. For example, when the spacing at the hole’s bottom between the blast hole and the drainage hole is 4.6 m, the volume of gas drainage increases by 3.3 times, compared with 8.8 m. Twenty-six protruding mines in southern China have applied the above deep-hole pre-splitting blasting technology, all of which have achieved good results and are of great significance to future applications in multiple fields, such as gas control.
This study devised a blasting experiment to establish a dynamic quantified relationship between blasting and movement, failure, and ejection of rock masses. The experiment was conducted using the 3D digital image correlation method (3D-DIC), which provided high-speed images capturing the process of shallow-buried tunnel blasting. The study analyzed the mechanical behavior of full-section rock mass under blasting action through cross-scale image processing. Yield and elastic points were distinguished based on the time–displacement curve. Then, the spatial vector method was employed to deduce flying rock trajectory and throwing distance, enabling the subdivision of underground space based on risk assessment. The results show that the rock in the cut zone starts moving within 3 ms after initiation, ultimately exhibiting a maximum visible off-plane displacement of 215 mm. Displacements are related to delay time and distance. Different zones show distinct dominant directions of rock mass displacement. The rock mass becomes flying rocks separated from the cross-section. The initial velocity of the flying rocks ranges from 11.8 m·s−1 to 29.9 m·s−1. Around 85% of the flying rocks fall within the range of 0 to 40.8 m. Only 5% of the flying rocks fall outside 64.3 m. Appropriate protective measures should be taken for equipment during experiments.