This paper presents three-phase switched-boost-modified Z-source inverter (ZSI) topologies with improved boost capabilities. In the proposed ZSIs, the voltage gain is increased significantly by adding one auxiliary switch and one diode without using additional passive components. The concept is applied to traditional ZSI, discontinuous input current quasi-ZSI (DC-qZSI), and continuous input current qZSI (CC-qZSI) resulting into three new inverter topologies: switched-boost ZSI, DC-qZSI, and CC-qZSI. Anatomization of operating principle, steady-state analysis, voltage gain, voltage stress, current stress, stored energy analysis, power loss, total harmonic distortion, and efficiency analysis are carried out to highlight the advantages of the proposed inverters as compared to the conventional ZSIs. Finally, the operation of the proposed CC-qZSI is validated through simulation and experimental results.
27 December 2017 in IEEE Transactions on Industry Applications
This paper proposes an interleaved hybrid converter (IHC) with simultaneous dc and ac outputs for dc microgrid applications. The IHC is realized by interleaving two conventional boost converters and replacing the active switch of lower boost converter by an H-bridge voltage source inverter. This arrangement enables the proposed IHC to operate at the condition where the sum of duty ratio (D) and modulation index (M) can be more than or equal to one, i.e., D + M ≥ 1, unlike the conventional hybrid converters. The proposed IHC is capable of giving dc with high voltage gain and improved ac with reduced harmonic distortion. Due to interleaving nature of the IHC, input current is shared between the power converters and thus enables the use of low current rated switching devices and lower values of inductors. This results in reduced power losses and increased efficiency as compared to the conventional hybrid converters. The IHC also has inherent shoot-through protection capability, better electromagnetic interference immunity, and reliability. A modified unipolar sinusoidal pulse width modulation technique is used to control the power flow of the IHC. Detailed mathematical modeling of the proposed IHC is carried out and its steady-state behavior is validated through experimental results on a 500 W laboratory prototype.
In this study, two quadratic boost derived hybrid multi‐output converter topologies are proposed. The proposed converters are capable of giving n ‐number of simultaneous ac and one dc outputs. The proposed converters are developed from a single switch quadratic boost converter by replacing its main switch by either n ‐number of series connected H‐bridge or n ‐number of parallel connected H‐bridge inverter topologies. The converter developed from n ‐series connected H‐bridge inverters give series mode of the proposed converter and is capable of giving n ‐number of ac outputs with variable voltages and same currents (to all the ac loads) along with one dc output. Further, the converter developed from n ‐parallel connected H‐bridge inverters give parallel mode of the proposed converter and can give n ‐number of ac outputs with same voltages (to all the ac loads) and variable currents along with one dc output. Due to the quadratic behaviour of the proposed hybrid multi‐output converters, high voltage gain can be achieved from small shoot‐through duty cycle. The proposed converter topologies can be applied for simultaneous dc/ac and dc/dc power conversion in a hybrid microgrid. Steady state and dynamic modelling have been carried out for analysing the steady state and transient behaviour of the proposed hybrid converters for two ac and one dc outputs. Simulation and experimental results are presented and efficiency analysis is carried out to validate the performance of the proposed converter topologies for two ac and one dc outputs.
Two novels switched Z-source inverters (ZSI) based on the active switched capacitor with high voltage conversion ratio are presented. These are active switched capacitor-based capacitor assisted extended boost ZSI and diode assisted extended boost ZSI. High voltage gain is required in various applications such as electric vehicles, grid integration of renewable energy sources, etc. The voltage gain of conventional ZSIs are limited and these conventional ZSI has high voltage conversion ratio at a high duty cycle, which results in poor inversion and poor efficiency. In this work, only one additional diode and one active switch are used with the conventional extended boost ZSI to achieve high voltage conversion ratio without adding any additional passive components. Compared to other ZSI topologies, the proposed inverter also guarantees low voltage across capacitors, a wide range of duty cycle operation and continuous source current in addition to high voltage conversion ratio. The detailed operating principles and steady-state analysis and design details are presented. The performance of the inverters is verified through simulation and also through experiments. Both the simulation and experimental results are presented.
The DC-DC converters are the essential modules in electric vehicles, grid interface of renewable energy sources and DC power supplies. This paper presents a novel high gain bidirectional switched Z-source DC-DC converter. The proposed bidirectional converter utilizes a switched-capacitor concept with inductors for high voltage gain. The proposed bidirectional converter has high voltage conversion ratio over a wide duty cycle range in both the boost and buck modes of operation. It has common ground between input and output, and uses only 5 active switches and 4 passive elements with reduced switch voltage stress. The current drawn from the low voltage side input source is continuous with reduced ripple. The operating principle, circuit analysis, design, mathematical model and closed-loop operation of the proposed converter are presented. The proposed converter is verified through computer simulation and laboratory experiments. The simulation and experimental results are presented.
17 December 2019 in IEEE Transactions on Power Electronics
This paper presents two hybrid multi output buck-boost quasi z-source converters (q-ZSCs) capable of giving two dc and one ac outputs simultaneously from a single dc input. One dc and the ac outputs of the proposed multi output q-ZSCs have both buck and boost capability and other dc output has the property of boosting the input voltage, thereby capable of giving wide range of voltage gain both for dc and ac outputs. The rationale behind proposing two variants of the hybrid multi output q-ZSCs is to have more flexibility on voltage gains as per the load requirements. All the three outputs of the proposed converters can be independently controlled making them suitable for various applications. Detailed steady state operation, loss/efficiency analysis of the proposed converter and discussion on the hybrid pulse width modulation is presented in the paper. In order to bring out the advantages of the proposed multi output converter, a detailed comparative analysis among the proposed and other closely related existing multi output converters is carried out in the paper. A 310 W prototype is developed to verify the performance of the proposed multi output buck-boost q-ZSC.