Distributed optical fiber sensors using Brillouin scattering have already demonstrated their ability to measure changes in strain and temperature over long distance. However, the simultaneous sensitivity of the Brillouin scattering to these two parameters is a real disadvantage during the instrumentation and monitoring of structures, such as for civil engineering, oil industry applications (i.e. instrumentation of pipelines or wells) or electrical power cables monitoring. In this article, we present a new instrument enabling independently measurement of temperature or strain using a unique fiber in a single measurement. This method, which we will call B-OTDR DSTS for "Distributed Strain and Temperature Sensing", is based on the measurement of frequency (as a standard BOTDR) but also intensity of Brillouin scattering. However, as the measurement of the latter requires an accurate measurement of power levels along the fiber, it is necessary to correct the losses by a Rayleigh OTDR measurement. The architecture of the BOTDR-DSTS allows simultaneous measurement of the Brillouin and Rayleigh backscatters. We will detail the validation results of this new device and show the interest of such a measurement on the instrumentation of a cable into a 2 km deep observation well.
Brillouin optical time‐domain reflectometry (BOTDR) has the advantage of requiring access to only one end of the sensing fibre, which is an important property for some applications. The coherent detection of spontaneous Brillouin scattering allows high sensitivity of temperature/strain measurements, close to one of the well‐known Brillouin optical time‐domain analyser‐based solutions. In‐line amplification based on bidirectional erbium‐doped fibre amplification (EDFA) modules can improve sensing distance and temperature accuracy. This study demonstrates a distributed sensing over 150 km with 5‐m spatial resolution and a temperature error of less than 2°C in 10 min without requiring specific BOTDR adaptation. A record performance of 0.7°C in 60 min has been also obtained, which corresponds to the best performance obtained in reflectometer configuration at this distance.
We propose the most suitable setup to have complete integrity monitoring of buried pipelines in permafrost using optical fiber sensing. Choice of best optical fiber cables and their best location near the pipe are discussed.
We report on a passively mode-locked oscillator based on an erbium-doped dual concentric core fiber combining high normal dispersion and large mode area. This large normal dispersion laser generates long pulses with 30 ps duration and 0.17 nm spectral width at 1530 nm wavelength. The source delivers an average power of 64 mW at a repetition rate of 16 MHz, corresponding to 4 nJ energy. This concept opens up new degrees of freedom in the design of mode-locked fiber lasers.
Modulation instability (MI) is a well-known limit for distributed fiber sensors. However, self-phase modulation (SPM) is rarely addressed as a standalone constraint in distributed acoustic sensing (DAS). This study demonstrates, through modeling and experiments, that SPM-induced spectral broadening causes significant backscattered signal losses and increased phase noise. These effects are particularly critical when using high-power, short Gaussian pulses commonly used to extend the sensing range. We highlight the predominant role of the detection bandwidth in these excess losses, proving that SPM is a limiting factor independent of MI for high-resolution nonlinear ϕ -OTDR measurements.