Based on a modified Mohr-Coulomb criterion with a non-uniform coefficient, a calculation method of plastic zone boundary of surrounding rocks in a circular tunnel in non-uniform stress field is established. Both the effects of intermediate principal stress and heterogeneity are studied. With the increase of the intermediate principal stress, the plastic zone size of the surrounding rocks will decrease first and then increase. Lateral pressure coefficient has an effect on the shape of the plastic zone. With the increase of lateral pressure coefficient, the plastic zone gradually becomes uniform, and the failure of surrounding rock develops upward and downward from both sides. As non-uniform coefficient increases, the material is more uniform and the effect of intermediate principal stress on the plastic zone is less significant. If the effect of intermediate principal stress is not taken into account, the calculation results tend to be consistent with results calculated by the Mohr-Coulomb criterion, which are considered to be conservative.
Blocky-rock masses are prone to dynamic slip along sand-filled joints under impact disturbance. The constraint normal to the joint and the size of the infill particles jointly influence their stability. To determine how axial load and particle-size affect dynamic slip, this study uses a custom-developed dynamic slip testing system for blocky-rock masses. Impact-disturbance tests are conducted under a constant lateral shear load with different axial load values and quartz-sand particle sizes. The block displacement evolves through three stages: stationary incubation, rapid slip, and deceleration to a stable state. When the axial load increases from 100 N to 400 N, residual slip displacement decreases by 87.52% to 90.12% across the particle size conditions. Residual slip displacement also follows an exponential decay with increasing axial load. Reducing particle size decreases both slip velocity and residual slip displacement, but its influence gradually weakens as the axial load increases. The difference in residual slip displacement between the coarse and fine particle conditions narrows from 0.460 mm to 0.030 mm. Strengthening the normal constraint compacts the granular layer and restricts particle movement, causing the dynamic slippage at sand-containing structural interfaces to gradually shift from being significantly influenced by the particle scale to being primarily controlled by the normal constraint.