The hybrid AC-DC microgrid (MG) has gained popularity recently as it offers the benefits of AC and DC systems. Interconnecting AC-DC converters are necessary since the MG has both DC and AC sub-grids. Adding an extra harmonic adjustment mechanism to the interlinking converters is promising because non-linear AC loads can worsen the quality of the voltage on the AC bus. The interlinking converters’ primary function is to interchange real and reactive power between DC and AC sub-grids, so the typical harmonic controlling approach implemented for active power filters (APFs) might not be appropriate for them. When the MG’s capacity is high, it is desirable that the switching frequency be lesser than the APFs. The performance of harmonic correction or even system stability may suffer at low switching frequencies. In this study, a harmonic compensating technique appropriate for hybrid AC-DC interlinking converters with lower switching frequencies is planned. The suggested strategy, modeling techniques, stability analysis, and a thorough virtual impedance design are discussed in this work.
This article presents a hybrid sine cosine algorithm with a teaching learning-based optimization (hSCATLBO) method to optimize the parameters of an Interval Type-2 Fuzzy Proportional Integral Derivative (IT2FPID) controlled Hybrid Shunt Active Power Filter (HSAPF) for reactive power and harmonic compensation. In this study, the optimal parameters for the IT2FPID controller are determined using a novel hSCATLBO method, focusing on Integral Time Absolute Error (ITAE). Unlike traditional (id-iq) or (p-q) techniques, the compensation strategy for HSAPF, only requires the current from the source side. The proposed system has been tested under extreme nonlinear load conditions, and various parameters such as Reactive Power (Q), Input Power Factor (IPF), and Total Harmonic Distortion (THD) have been assessed to liken the performance of the anticipated controller. The proposed hSCATLBO-IT2FPID-HSAPF has been experimentally verified using dSPACE. The comparative analysis reveals that the hSCATLBO-optimized IT2FPID-HSAPF provides superior harmonic compensation when compared with hSCATLBO-optimized Type-1 Fuzzy Proportional Integral Derivative (T1FPID) controller-based HSAPF under different operating conditions.
Reactive Power & Harmonic compensation (RPHC) represents a crucial area of investigation within the domains of power engineering. While passive filters have traditionally been favored for mitigating harmonics, their size becomes impractical when addressing multiple harmonics. In contrast, active power filters offer enhanced performance and address the limitations of passive filters, albeit at a higher cost. This study introduces a Shunt Hybrid Active Filter (SHAF) designed for RPHC. In our approach, the Kalman Filter (KF) is utilized for estimation of reference current per-unit (PU) quantity and the current reference crest value, which are derived from a Type-2 Fuzzy Fractional Order PID Controller (T2FFOPIDC). The optimal parameters for the T2FFOPIDC are determined using an innovative hybrid Particle Swarm Optimization (PSO) Firefly Algorithm (hPSOFA), with a focus on minimizing the ITAE. The suggested system is validated, taking balanced as well as unbalanced nonlinear loads, and the outcomes are contrasted with those obtained from an SHAF system based on the Type-1 Fuzzy Fractional Order PID Controller (T1FFOPIDC), which is also optimized using hPSOFA. The compensation strategy employed in the SHAF differs from the conventional (id–iq) or (p–q) techniques, as it necessitates the current from the source side. Various performance metrics, including Reactive Power (Q), THD, and PFS, are assessed to evaluate the effectiveness of the proposed controller. Case studies reveal that the hPSOFA-T2FFOPIDC-based SHAF demonstrates superior RPHC compared to the hPSOFA-T1FFOPIDC-based SHAF across various operational scenarios. Furthermore, the performance of the proposed hPSOFA-T2FFOPIDC-SHAF has been experimentally validated using dSPACE.