Inchworm piezoelectric actuators have attracted much attention in the field of precision positioning due to the advantages of a large stroke, high output force, and high resolution. However, traditional inchworm piezoelectric actuators use two sets of clamps and a set of drive structures to achieve stepping motion, which generally requires at least three piezoelectric stacks, resulting in a complex structure and the control system. Several methodologies have been advanced to minimize the utilization of piezoelectric stacks. However, there still exists the issue of excessive volume. Therefore, an inchworm piezoelectric actuator with a single-clamp and single drive structure is proposed in the study, which provides a compact size and smaller volume. The clamping mechanism comprises two sets of clamping feet with opposite displacement, which alternate contact with the guide frame and adjustable plate to ensure that the clamping mechanism always has frictional force and accomplishes the stepping motion. The testing of the actuator’s step distance, output force, and other parameters was conducted utilizing a displacement sensor. Experimental results indicate that the actuator achieved a maximum speed of 174.3 μm/s and an output force of 8.6 N when the frequency and voltage were 19 Hz and 150 V.
Screws are critical mechanical components, and their geometric accuracy directly determines the performance and reliability of mechanical systems. However, conventional contact-based inspection methods are time-consuming and limited to sparse sampling. Existing non-contact optical techniques often suffer from insufficient edge localization accuracy due to discrete point spacing. To address these challenges, this paper proposes a vision-guided point cloud refinement measurement method. The system integrates a laser scanner with a camera, where the laser scanning serves as the primary channel for acquiring three-dimensional point clouds, and the vision system provides high-resolution thread edge positions through sub-pixel localization and interpolation. A joint 2D-3D registration procedure is established to transfer the 2D sub-pixel edge localization precision to the corresponding 3D points, effectively correcting the spatial positions of thread crests. A coarse-to-fine processing pipeline is then applied, encompassing PCA-based principal axis alignment, Fourier transform-based coarse pitch estimation, and Gaussian pyramid-based multi-resolution refinement, to extract the pitch from the refined point cloud. Experimental validation on a real screw specimen confirms that the proposed method achieves a pitch measurement error of 0.0423 mm, demonstrating performance comparable to the pure vision-based method. It can provide a reliable solution for high-precision screw thread inspection.