The high strain rate deformation behavior and microstructure evolution of in situ TiB2 particle reinforced Al-Zn-Mg-Cu composite were investigated by means of Taylor impact. The dynamic tests were performed at three different impact velocities. Under three different velocities, no obvious shear failure occurred in the composite, indicating a good impact resistance. Compared to the quasi-static compression test, the dynamic yield strength increased obviously with the rise of velocity, even more than 1 GPa. The dislocation multiplication, phonon drag effect and ceramic reinforcement increased the flow stress of composite. Fine, equiaxed grain structure developed after impact, resulting from grain fragmentation or dynamic recrystallization. Finite element simulation of Taylor impact was qualitatively in agreement with the experiments, which was useful to elucidate the formation of equiaxed grain structure.
The evaluation of structural crashworthiness is important for the development of civil aircraft. In this study, cargo luggage was considered in the vertical drop simulation of an aircraft mid-fuselage section. First, quasi-static compression tests on three types of luggage made of different materials were conducted. Then, a finite element model (FEM) of the cargo luggage was developed with a crushable foam material in LS-PrePost4.5 software. The finite element analysis results of the luggage made of different materials were consistent with the corresponding compression experiments. Secondly, the FEM of the mid-fuselage section was established without cargo luggage. The simulated displacement and acceleration of the fuselage section were consistent with the test results. Finally, the influences of cargo luggage on the fuselage vertical drop response were studied with the FEM considering both the fuselage structure and cargo luggage. Compared with the responses of the fuselage without cargo luggage, the cargo luggage could reduce the deformation of the cargo bay and maintain the integrity of the passenger living space in the cabin at the vertical velocity of 6 m/s, even though the initial kinetic energy was higher.
Understanding the rate-dependent deformation and energy absorption behavior of architected lattice structures is essential for developing lightweight impact-resistant materials. This study investigates the effects of loading rate and relative density on the mechanical response of additively manufactured acrylonitrile butadiene styrene (ABS) gyroid structures. Quasi-static and dynamic compression experiments were conducted, and PAM-CRASH finite element simulations were validated against the experimentally investigated compression conditions and subsequently used to explore responses beyond the experimentally accessible velocity range. The results show that both the initial peak crushing force and mean crushing force increase with increasing relative density and loading velocity, with distinct strengthening characteristics from quasi-static loading to high-velocity impact. Increasing loading velocity induces a transition in deformation behavior from homogeneous layer collapse to localized shear banding and fracture. At 100 m/s, the numerical simulations further predict a transition toward inertia-dominated layer-by-layer collapse. Lower-density structures exhibit higher sensitivity to loading rate, with deformation transitions occurring at lower velocities. Although total energy absorption increases with loading velocity, the specific energy absorption shows limited dependence on relative density under high-velocity loading. These results highlight the coupled effects of loading rate and relative density on the deformation and energy absorption of gyroid structures and provide insights into the design of lightweight lattice structures for impact-resistant applications.