Xianjin Yin

Mr. Xianjin Yin


Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 June 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
JLJinlie Li
Jinlie Li
TMTianyu Ma
Tianyu Ma
XYXianjin Yin
Xianjin Yin
Feng WangFeng Wang
Feng Wang
ZLZhuangzhuang Li
Zhuangzhuang Li
ZZZheng ZL
Zheng ZL
High-power-density insulated gate bipolar transistor (IGBT) modules in new energy vehicles require efficient heat dissipation and good temperature uniformity. This study proposes a tri-objective topology optimization method for a liquid-cooled heat sink using average temperature, temperature variance, and flow dissipation as the objective functions. A two-dimensional model was established in COMSOL to investigate the effects of the fluid volume fraction, inlet pressure, and optimization-weight distribution on the optimized topology and thermo-hydraulic performance. The results show that a fluid volume fraction of 0.4 and an inlet pressure of 15 Pa provide the best overall performance. Compared with the bi-objective design, introducing temperature variance as a third objective reduces temperature variance by 50.23%, with only a 1.08% increase in average temperature. Three-dimensional simulations further verify the optimized design. Compared with a conventional pin-fin heat sink, the topology-optimized structure reduces the average temperature by 10.43% and the temperature variance by 44.37%, while increasing the flow dissipation by 49.57%. These results show that tri-objective topology optimization is an effective method for improving the thermal management of high-power-density IGBT modules.

11 September 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
XYXianjin Yin
Xianjin Yin
TMTianyu Ma
Tianyu Ma
WDWANG Dou
WANG Dou
Feng WangFeng Wang
Feng Wang
To address the challenge of quantitatively identifying thermal-resistance contributions from multi-layer packaging structures within liquid-cooled insulated-gate bipolar transistor (IGBT) modules, this study establishes a three-dimensional conjugate heat-transfer model incorporating the chip, solder layer, direct-bonded copper (DBC) ceramic layer, substrate, elliptical pin-fin heat sink, and fluid domain. The IGBT and fast-recovery diode (FRD) power losses under typical motor controller operating conditions are modeled as volumetric heat sources applied to the chip region. Based on model validation, an internal thermal bottleneck evaluation method is proposed using inter-layer temperature-drop decomposition, introducing the thermal bottleneck number (BN) to quantify the temperature-drop contribution of each packaging layer along the target chip’s heat-dissipation path. Results show that in the baseline structure, the DBC ceramic layer is the critical internal thermal bottleneck, with a BN value of 11.05%. When the DBC thermal conductivity increases from 20 W/(m·K) to 80 W/(m·K), the maximum junction temperature of the IGBT decreases from 413.32 K to 396.79 K, and the BN drops from 11.05% to 3.69%. Conversely, when the DBC thickness increases from 0.20 mm to 0.50 mm, the maximum junction temperature rises from 405.45 K to 424.42 K. Further analysis reveals that after weakening the DBC thermal bottleneck, the relative temperature-drop contribution of the solder interface becomes increasingly apparent; notably, a central 20% low-conductivity defect in the solder layer raises the maximum junction temperature to 517.16 K, 103.84 K higher than under normal solder conditions. These findings provide valuable insights for identifying internal thermal bottlenecks and optimizing packaging structures in liquid-cooled IGBT modules.