Liquid exfoliated molybdenum disulfide (MoS2) nanosheets and polyaniline (PANI) nanoparticles are dispersed in polystyrene (PS) matrix to fabricate hybrid polymer composites with high dielectric and electromagnetic interference (EMI) shielding behavior. A phase-separated morphology is formed when PANI and MoS2 are incorporated into polystyrene (PS) matrix. An increasing concentration of MoS2 nanoparticles inside PS/PANI (5 wt %) polymer blend forms an interconnected network, resulting in high electrical conductivity and dielectric behavior, making them a suitable candidate for EMI shielding application. An increment in dielectric constant and loss, up to four and five orders of magnitude, respectively, is recorded at a maximum concentration of 1 wt % of MoS2 in PS/PANI-5 polymer blend at 100 Hz. The enhanced dielectric characteristics for PS/PANI/MoS2 composites are then theoretically evaluated for the estimation of EMI shielding effectiveness in the frequency range of 100 Hz to 5 MHz. The maximum dielectric constant and loss achieved for PS/PANI-5 wt %/MoS2-1 wt % are responsible for estimated shielding effectiveness of around 92 dB at 100 Hz. The increase in dielectric behavior and shielding effectiveness is probably due to the increased number of charged dipoles accumulated at the insulator–conductor interface.
In this research, silica nano-particles are deposited over the borosilicate glass and silicon wafer substrates by indigenously developed Aerosol impact deposition assembly using SiH4, oxygen, and helium as precursors. The coating process involves deionization of gases leading towards nucleation sites for silica in the presence of plasma, while tuning the pressure difference between reaction and deposition chamber controls the coating thickness, porosity, and refractive index. The deposited coating layer on the substrate enhanced the transmittance to 99.6% at 600 nm wavelength. The induced porous nature and the graded index of the coated layer as observed from the AFM and SEM resulted in superhydrophilic behavior with a water contact angle of near to 0°. The super-hydrophilicity of the coating contains self-cleaning properties, suggesting an improvement of the performance of solar PV modules as well.
ZnO/GO (Graphene Oxide) and SAN (Styrene Acrylonitrile)/PANI (Polyaniline)/FLG (Few Layers Graphene) nanocomposite coatings were produced by solution casting and sol-gel methods, respectively, to enhance corrosion resistance of ferrous based materials. Corrosive seawater and ‘produced crude oil water’ environments were selected as electrolytes for this study. Impedance and coating capacitance values obtained from Electrochemical Impedance Spectroscopy (EIS) Alternating Current (AC technique) showed enhanced corrosion resistance of nanocomposites coatings in the corrosive environments. Tafel scan Direct Current (DC technique) was used to find the corrosion rate of nanocomposite coating. SAN/PANI/FLG coating reduced the corrosion of bare metal up to 90% in seawater whereas ZnO/GO suppressed the corrosion up to 75% having the impedance value of 100 Ω. In produced water of crude oil, SAN/PANI/FLG reduced the corrosion up to 95% while ZnO/GO suppressed the corrosion up to 10%. Hybrid composites of SAN/PANI/FLG coatings have demonstrated better performances compared to ZnO/GO in the corrosive environments under investigation. This study provides fabrication of state-of-the-art novel anti corrosive nanocomposite coatings for a wide range of industrial applications. Reduced corrosion will result in increased service lifetime, durability and reliability of components and system and will in turn lead to significant cost savings.