New approaches and techniques are required for environmental management in workplaces that emit pollutants. The best available techniques (BATs) that are suggested by the integrated environmental permit system (IEPS) play a pivotal role in providing state-of-the-art approaches and techniques to workplaces. For the workplaces that install facilities with the BATs, it is necessary to perform real-time monitoring to determine whether pollutant emission facilities and treatment facilities are operating normally and whether such facilities can maintain the optimal condition during the emission of pollutants. The environmental management measures used before the IEPS had limitations for workplaces that are subjected to integrated environmental management because they consider the entire workplace as a single pollution source by combining all media. In addition, only the emission concentrations and amounts of pollutants were monitored because only the points at which most pollutants are discharged, i.e., stacks for air pollutant emission facilities and final effluent outlets for water pollutant emission facilities, are monitored. These monitoring approaches in a variety of facilities involve considerable costs, and most of them (95% for stacks in workplaces under IEPS, Korea) cannot perform real-time observation even though some of them are capable of it (5% for stacks managed by Tele Monitoring System, TMS). In this study, the applicability of a wireless sensor monitoring network was examined as a new approach for environmental management in workplaces. Based on the sensor monitoring network, surrogate parameters that can indirectly monitor the critical operating factors of pollutant emission and prevention facilities were developed and then measured in real time to examine the status of these facilities. Surrogate parameters can be used instead of directly measuring pollutants as the former has high efficiency, such as cost reduction, and can provide reliable data on the emission characteristics of pollutants. The wireless network is based on an Internet of Things (IoT) platform under real-time conditions in the emission and production facilities in a workplace. This study suggested that a wireless network using the IoT platform improves the BAT assessment methodology to understand the efficiency of environmental pollution reduction and the economic contribution to the workplace.

The South Korean government has implemented an acceptance system to promote the high-quality recycling of waste. Industrial waste generators must provide “hazardous characteristics data” to recycling operators. Nonetheless, ~80% of industrial safety accidents in South Korea occur during recycling, most involving fire or explosions. Moreover, a gap in safety management exists during ‘Circular Resource’ acceptance if the target substance is not regarded as waste. In this study collected data on hazardous waste characteristics. From 62 waste generators, 72 waste samples were collected, accounting for most of the resources accepted for recycling, including waste synthetic polymers, slag, dust, waste sand, and waste foundry sand. Then, the hazardous characteristics, as stated in the Ministry of Environment notifications, were assessed. Leaching toxicity was detected in one slag sample and six dust samples. The Cd, Cu, As, Pb, Zn, Ni, Hg, F, and CN levels dissatisfied the Soil Contamination Warning Standard in 31 samples. Explosivity was not detected in any sample, whereas flammability was detected in one waste synthetic polymer sample. The results revealed 15 cases of potential flammability. Flammability is legally defined as below the criteria if the combustion speed criterion is not met. However, in the case of flame ignition, which could cause large fires and safety accidents, the relevant notification should be revised. In this study, we aimed to improve the gap between the hazardous waste management systems and industrial fields through actual measurements of hazardous characteristics. By doing so, we seek to contribute to the prevention of environmental and safety accidents. By continuously accumulating data and utilizing actual measurements, we aim to revise and enhance relevant regulations, ultimately improving the hazardous characteristics of waste management systems.