With an increasing use of plastic, considerable plastic waste is generated, threatening the environment and public health. In particular, changes in living patterns in urban areas have significantly impacted the rate at which plastic waste increases every year. Thus, governments in many developed countries have implemented numerous policies to reduce plastic waste generation. Among them is the concept of circular economy that aims to protect the environment from plastic pollution and promote growth and innovation in industry and human life through overall changes in designing, producing, using, and recycling plastic products. The Korean government has implemented the Resource Circulation Act (RCA), which includes the concept of circular economy and resource efficiency policy for overall waste management. Following the concept of RCA, the Plastic Waste Control Plan (PWCP) was established for the comprehensive management of plastic waste. Therefore, this study introduces the goals and strategies of PWCP, which has a circulation system of four stages of production, consumption, discharge, and recycling, as well as the major roadblocks in the stages impeding the achievement of the goals and strategies. This study also suggests countermeasures at the government level for solving the major problems in the four stages.

The characteristics of bioliquid produced through the hydrothermal carbonization (HTC) of wood wastes and the effects of recirculation on hydrochar production were analyzed. The organic acids and total organic carbon of bioliquid increased with progressive recirculation, whereas intermediate byproducts decreased. Hydrochar production by bioliquid recirculation increased mass yield, carbon content, caloric value, and energy yield of the former, while improving its quality as a solid refuse fuel. We concluded that bioliquid recirculation promoted HTC, as demonstrated by Fourier-transform infrared spectroscopy. Furthermore, contrary to predictions, a relatively constant quantity of bioliquid was generated in each step, indicating that its continuous reuse is feasible. Therefore, bioliquid recirculation can improve hydrochar production while simultaneously mitigating the environmental impact of wastewater generation. This method should be considered an important strategy toward the implementation of carbon-neutrality goals.

The South Korean government has implemented an acceptance system to promote the high-quality recycling of waste. Industrial waste generators must provide “hazardous characteristics data” to recycling operators. Nonetheless, ~80% of industrial safety accidents in South Korea occur during recycling, most involving fire or explosions. Moreover, a gap in safety management exists during ‘Circular Resource’ acceptance if the target substance is not regarded as waste. In this study collected data on hazardous waste characteristics. From 62 waste generators, 72 waste samples were collected, accounting for most of the resources accepted for recycling, including waste synthetic polymers, slag, dust, waste sand, and waste foundry sand. Then, the hazardous characteristics, as stated in the Ministry of Environment notifications, were assessed. Leaching toxicity was detected in one slag sample and six dust samples. The Cd, Cu, As, Pb, Zn, Ni, Hg, F, and CN levels dissatisfied the Soil Contamination Warning Standard in 31 samples. Explosivity was not detected in any sample, whereas flammability was detected in one waste synthetic polymer sample. The results revealed 15 cases of potential flammability. Flammability is legally defined as below the criteria if the combustion speed criterion is not met. However, in the case of flame ignition, which could cause large fires and safety accidents, the relevant notification should be revised. In this study, we aimed to improve the gap between the hazardous waste management systems and industrial fields through actual measurements of hazardous characteristics. By doing so, we seek to contribute to the prevention of environmental and safety accidents. By continuously accumulating data and utilizing actual measurements, we aim to revise and enhance relevant regulations, ultimately improving the hazardous characteristics of waste management systems.