SAIT KIZGUT

Prof. Dr. SAIT KIZGUT

orcid

Research Focus & Metrics

Academic Career Length

32Years (1995-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 May 2006 in Journal of Thermal Analysis and Calorimetry
Verified
Journal Article
Closed access
PDF file
SKSAIT KIZGUT
SAIT KIZGUT
KBK. Baris
K. Baris
SYSerdar Yılmaz
Serdar Yılmaz

24 May 2013 in Particulate Science and Technology
Verified
Journal Article
Closed access
ACA. D. Cuhadaroglu
A. D. Cuhadaroglu
SKSAIT KIZGUT
SAIT KIZGUT
SYSerdar Yılmaz
Serdar Yılmaz
YZY. Zorer
Y. Zorer
The purpose of this study is to determine the grindability and kinetic behavior of clinker and colemanite in cement production when they are ground separately and together. Bond and Hardgrove grindability methods were employed to determine grindability properties clinker and colemanite by varying proportions. Bond work index (BWI) values of clinker and colemanite are 18.89 kWh/t and 12.33 kWh/t, respectively. BWI value of mixture decreases by added colemanite and the experimental BWI values of mixtures were lower than those of calculated, considering their proportions. Hardgrove grindability index (HGI) values of clinker and colemanite are 51.81 and 99.62, and Blaine fineness values are 920 cm2/g and 2430 cm2/g, respectively. As colemanite addition increases HGI and Blaine fineness values also increase. Experimental Blaine fineness values are greater than calculated values meaning that during intergrinding different ingredients do not show the same behavior as in the case of separate grinding. These findings explain that clinker particles have an abrasion effect thus an extra grinding effect on colemanite particles. The specific rates of breakage were determined through kinetic experiments to understand the grinding mechanisms of colemanite, clinker and their mixtures. The model parameters of Si, aT, and α were established in kinetic experiments.

1 March 2003 in Journal of Thermal Analysis and Calorimetry
Verified
Journal Article
Closed access
PDF file
SKSAIT KIZGUT
SAIT KIZGUT
YBY. Baran
Y. Baran
DCD. Cuhadaroglu
D. Cuhadaroglu

15 December 2015 in Combustion Science and Technology
Verified
Journal Article
Closed access
SKSAIT KIZGUT
SAIT KIZGUT
MBMehmet Bilen
Mehmet Bilen
İTİhsan Toroğlu
İhsan Toroğlu
KBKemal Barış
Kemal Barış
The unburned carbon (UBC) content of ash from coal-fired thermal power stations and plants that use massive amount of coal can sometimes be 6–7% or more; this simply means loss of carbon and decrease in efficiency. Carbon loss not only causes a decrease in efficiency but is also an economical issue. Decreasing the carbon content would provide the usage of ash from thermal power stations as cement additives. Many factors cause low combustion efficiency and a high amount of UBC. In the course of this study, fly ash and bottom ash were divided into size fractions and accumulation of UBC at coarser size fractions was observed. In this study, a ground coal sample from a mill was sieved, and the accumulation of UBC at coarser size fractions was associated to a lack of grinding of pulverized coal. Ground coal has a size distribution where 54.45% was below 75 µm, and 45.55% was still over this critical size. A significant amount (35.48%) of the UBC accumulated in the size fraction over 75 µm in fly ash, whereas almost 70% accumulated in the size fraction over 0.5 mm in bottom ash. Coal and ash samples were observed under a microscope to deduce origins of UBC.

1 January 1995 in Coal Science and Technology
Verified
Book Chapter
Closed access
SKSAIT KIZGUT
SAIT KIZGUT
NMN. Miles
N. Miles
MCM. Cloke
M. Cloke

21 November 2023 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Verified
Journal Article
Closed access
HGHalil İ̇brahim Gonul
Halil İ̇brahim Gonul
MBMehmet Bilen
Mehmet Bilen
SKSait Kızgut
Sait Kızgut